User manual PEAVEY GENERATION 1

[. . . ] Refer servicing to qualified service personnel. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. Before using this appliance, read the operating guide for further warnings. Este símbolo tiene el propósito, de alertar al usuario de la presencia de "(voltaje) peligroso" sin aislamiento dentro de la caja del producto y que puede tener una magnitud suficiente como para constituir riesgo de descarga eléctrica. [. . . ] However, by adjusting the squelch controls it affects the sensitivity level of the receiver, therefore, shortening the operating distance and decreasing the stability. Figure 9 3. Under normal circumstances, the SIGNAL indicator lights up when a microphone or transmitter is turned on near the receiver to indicate the receiver is ready for normal operation. Once sounds enter into the microphone the AUDIO LED indicators will 10 illuminate according to the strength of sound level. If the LEDs do not illuminate or sound is not present at the output, the system is not functioning properly and must be checked. RECEIVER AND AMPLIFIER VOLUME ADJUSTMENT: a. Unbalanced Audio Output: Switch the level switch on the rear panel of the receiver to the left "LOW" Position, then adjust the volume control to twelve o'clock position. Adjust the volume control of the amplifier or mixer to an appropriate sound level. The volume control is used for fine adjustment of the microphone sensitivity. When the knob is turned to the twelve o'clock position the output sensitivity level of the wireless microphone is the same as a normal dynamic microphone. Once the receiver output level is appropriately adjusted, do not adjust the volume control again. Adjust the mixer or amplifier volume control if the sound level needs to increase or decrease. Please take care when changing the switch settings, the switches are fragile components. Your local dealer/ distributor will be able to help you with advice as to the specific frequencies represented by the various group/ channel combinations available to you. This information may be useful, particularly in a multi use venue. 13 HANDHELD WIRELESS MICROPHONE TRANSMITTER Like the receiver, the hand held microphone features advanced synthesized PLL design. It is preprogrammed with 30 user selectable frequencies and incorporates "Superior frequency tracking and muting techniques" dual squelch circuitry. The unique soft velvet rubber finish and overall balance of the microphone offers comfort and durability for the user. If no flash is observed, then it is likely the polarity is incorrect or the battery is dead flat and needs to be replaced. Replace the grill/ball screen assembly, taking care to line up the 3 pins and polarizing lug with the 3 contractor plates. Screw the grill/ball screen back in to place, taking care not to force the turns. If the grill/ball screen assembly appears to either not engage, or tries to cross thread, remove it and check for the correct alignment of the pins. 2. 3. 2. OPERATION OF THE HAND HELD TRANSMITTER When the microphone is switched on, the led indicator will flash briefly to indicate that the battery is OK and that the transmitter is powered up. At the receiver, the RF indicator will illuminate almost immediately to indicate that a RF link has been established and the AF indicator will illuminate 16 once audio is present. As mentioned previously, the level of these two indicators will indicate their signal strength at the receiver. [. . . ] Features and specifications subject to change without notice. 26 IMPORTANT SAFETY INSTRUCTIONS 1. WARNING: When using electric products, basic cautions should always be followed, including the following: Read these instructions. For example, near or in a bathtub, swimming pool, sink, wet basement, etc. Do not block any of the ventilation openings. [. . . ]