User manual PEAVEY HDH

[. . . ] IEC POWER SOCKET: With the Power Switch (#2) in the off (O) position, plug the power cord into this connector prior to plugging it into your AC power source. Always insure that proper grounding practices are utilized. Damage to the equipment may occur if improper line voltage is used (see voltage marking on unit). Never remove or cut the ground pin of the line cord plug. [. . . ] MIC (LOW Z) INPUT XLR balanced low impedance channel input optimized for a microphone or other low impedance source. This connector has +15V phantom power supply on Pins 2 and 3 at all times (Pin 1 is the ground reference). LINE (HIGH Z) INPUT 1/4" unbalanced input that accepts line level sources equipped with a 1/4" plug (TS). The two inputs (XLR and 1/4") cannot be used simultaneously. lEVEL Sets the level of the individual channel in the mix. REVERB Sets the level of the internal reverb for the channel and must be used in conjunction with the master reverb level. EQ boost is obtained by moving a particular EQ band's control above the "0" position. EQ cut is obtained by moving a particular EQ band's control below the "0" position. The following list describes each EQ control and its center frequency. Low - shelving type - 80 Hz Mid - peak type - 1 kHz High - shelving type - 10 kHz OPERATION NOTE: This equalizer is designed to provide room equalization, feedback control and system tone control. No amount of equalization will correct the response curve of a poor loudspeaker. Include a detailed description of the problem, together with a copy of your sales receipt or other proof of date of purchase as evidence of warranty coverage. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This Warranty gives you specific legal rights, and you may also have other rights which vary from state to state. If you have any questions about this warranty or service received or if you need assistance in locating an Authorized Service Center, please contact the Peavey International Service Center at (601) 483-5365 / Peavey Canada Ltd. Features and specifications subject to change without notice. WARNING: When using electric products, basic cautions should always be followed, including the following: 1. For example, near or in a bathtub, swimming pool, sink, wet basement, etc. Do not block any of the ventilation openings. install in accordance with manufacturer's instructions. It should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air. [. . . ] Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus. Use only with a cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over. [. . . ]