User manual PEAVEY HDH-2 DATASHEET

[. . . ] Refer servicing to qualified service personnel. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. Before using this appliance, read the operating guide for further warnings. Este símbolo tiene el propósito, de alertar al usuario de la presencia de "(voltaje) peligroso" que no tiene aislamiento dentro de la caja del producto que puede tener una magnitud suficiente como para constituir riesgo de corrientazo. Este símbolo tiene el propósito de alertar al usario de la presencia de instruccones importantes sobre la operación y mantenimiento en la literatura que viene con el producto. [. . . ] Plug your footswitch into the Remote Switch jack on the rear of the unit. Turn your guitar volume down and turn the amp on via the power switch on the back of the unit. Gradually turn the volume of your guitar all the way up or until you are comfortable with the level/tone. Experiment with the footswitch to become familiar with how the different features are selected. 3 Step 10. To adjust the overall level, use the Master Gain control. To adjust out any undesirable distortion, use the Pre Gain knob. Turning the knob counterclockwise results in a decreased level, thus reducing the overdriven signal. Any external effects units can also cause the signal to overdrive. You should be able to play at this time. Vary the Reverb and/or EQ knobs to get a feel for their effect on your tone. Most importantly. . . . READ THE REST OF THIS MANUAL. Master Reverb (9) Adjusting this control clockwise will result in more reverb content in the output of the amp. The reverb can be defeated by rotating the control counterclockwise or via the footswitch. Master Gain (10) The Master Gain controls the overall volume level of the amplifier. The final adjustment to this control should be made after the desired sound/tone has been achieved. Power LED (11) The Power LED illuminates when power is supplied to the amp. Power Switch (12) Placing this switch in the ÒOnÓ position will result in power being supplied to the unit. The Power LED (11) will illuminate when the amp is on. REAR PANEL 13 14 15 16 Remote Switch (13) This jack is provided for the connection of the supplied footswitch. The footswitch is a multi-function type, allowing you to to defeat the Reverb and/or the Post EQ Patch loop. To use the footswitch, insure that the footswitch plug is inserted fully into the jack. Power Amp In (14) This mono 1/4" jack provides an input to the power amplifier. [. . . ] Do not block any of the ventilation openings. Install in accordance with manufacturerÕs instructions. It should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air. Do not install near any heat sources such as radiators, heat registers, stoves or other apparatus (including amplifiers) that produce heat. [. . . ]