User manual PEAVEY HDH-2T DATASHEET

[. . . ] Protect the power cord from being walked on or pinched, particularly at plugs, convenience receptacles, and the point they exit from the apparatus. Note for UK only: If the colors of the wires in the mains lead of this unit do not correspond with the terminals in your plug, proceed as follows: a) The wire that is colored green and yellow must be connected to the terminal that is marked by the letter E, the earth symbol, colored green or colored green and yellow. B) The wire that is colored blue must be connected to the terminal that is marked with the letter N or the color black. C) The wire that is colored brown must be connected to the terminal that is marked with the letter L or the color red. [. . . ] If the amp repeatedly blows fuses, it should be taken to a qualified service center for repair. REMOVABLE AC POWER CORD This receptacle is for the IEC line cord (included), which provides AC power to the unit. Connect the line cord to this connector and to a properly grounded AC supply. Damage to the equipment may occur if an improper line voltage is used. ) Never remove or cut the ground pin of the line cord plug. This unit is supplied with a properly rated line cord. When lost or damaged, replace this cord with one of the proper ratings. (For UK Only) As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows: · The wire which is coloured green and yellow must be connected to the terminal which is marked by the letter E or by the earth symbol, or coloured green or green and yellow. ⷠThe wire which is coloured blue must be connected to the terminal which is marked with the letter N or coloured black. ⷠThe wire which is coloured brown must be connected the terminal which is marked with the letter L or the coloured red. This section will help you locate the two speaker output jacks on the rear of your HDH-2T. Failure to do so may cause oscillation or other strange effects. This is due to feeding signal returned from the effects loop back into the effects loop resulting in a feedback. MAIN OUTPUT 1/4" unbalanced output that can be used as a source for an external amplifier/speaker system, feed to other mixers or a tape deck. This signal is taken after the master fourband equalizer. POWER LED Illuminates when AC power is being supplied to the mixer. mASTER EQUALIZATION Provides ±12 dB equalization at each center frequency. EQ boost is obtained by moving a particular EQ band's control above the "0" position. EQ cut is obtained by moving a particular EQ band's control below the "0" position. The following list describes each EQ control and its center frequency. Low - shelving type - 40 Hz Low Mid - peak type - 300 Hz High Mid - peak type - 2 kHz High - shelving type - 10 kHz OPERATION NOTE: This equalizer is designed to provide room equalization, feedback control and system tone control. No amount of equalization will correct the response curve of a poor loudspeaker. [. . . ] Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as powersupply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. If this product is to be mounted in an equipment rack, rear support should be provided. Exposure to extremely high noise levels may cause a permanent hearing loss. [. . . ]