User manual PEAVEY IMPACT TORINO I

[. . . ] Before using this appliance, read the operating guide for further warnings. WARNING: When using electrical products, basic cautions should always be followed, including the following: Do not use this apparatus near water. Do not block any of the ventilation openings. install in accordance with manufacturer's instructions. [. . . ] These speakers should not exceed 29" in height or 70 lbs. The stand pole must be fully seated all the way down into the Impulse 115P pole tunnel before any speaker can be mounted on top of the pole. If you are using an extension cord or power strip with this powered speaker, make sure it is of good quality and of a sufficient current capacity to maintain safety and maximize the power output capability of the Impulse 115P. Do not connect any other device to the same extension cord that the Impulse 115P is connected to. There are a variety of ways to get a signal to the Impulse 115P. The balanced line-level input(s) allow the use of a 1/4" phone plug: either a standard single-ended TS (tip/sleeve) plug or a balanced RTS (ring/tip/sleeve) type plug. Do not connect cables to the jacks while the units are on and the volume is turned up. While the standard, single-ended 1/4" phone plug will work and the balanced input circuitry will provide some interference rejection, a balanced cable using either the TRS 1/4" plug or the XLR plug will provide superior performance. Plugging into the RCA jacks or plugging a mono, 1/4" plug into the combo jack will cause the thru jack to operate in unbalanced mode. Sometimes, with difficult interference problems, it will be helpful to lift the shield ground on a balanced cable at the Impulse 115P end only. This can be accomplished via the convenient ground lift switch (10a) found underneath the input jack group. This will become the Left channel of the total system. This will become the Right channel of the total system. Use of the Left channel In and Out on each Impulse 115P assures proper overall system operation. This setup can be repeated for each Impulse 115P connected for any number of channels. The Impulse 115P is designed with multiple, parallel inputs which allow daisy-chaining from one Impulse 115P to another. Connect the first cable from the mixer output to the first Impulse 115P. Then, connect a cable from the first Impulse 115P's Thru jack to the second Impulse 115P's input. This connection can be continued for several units, depending on the total length and capacitance of the cables. With a lowsource impedance output from a typical mixer and by using quality, balanced cables, several Impulse 115Ps can be daisy-chained from one output using 30 or 40 foot cables without obvious problems or distortion. Do not connect cables to the jacks while the units are On and the Volume is turned up. The Impulse 115P has a variety of applications such as sound reinforcement, public address or musical playback. [. . . ] make sure to check the rear panel screws and the baffle screws. The unit, in use, is subject to a great deal of vibration which can cause the screws to loosen over time. One combo female XLR/1/4" phone jack providing balanced operation Greater than 90 dB below rated power (@ 120 VAC line) Subwoofer Section only 1500 W peak dynamic power, bridged mode 1000 W continuous @ less than 0. 3% distortion Left & Right Output Section only 750 W peak dynamic power either channel All Channels Loaded Full Subwoofer Section 750 W peak dynamic power 500 W continuous Left & Right Output Section 375 W peak dynamic power either channel 250 W continuous Satellite stand mounting via built-in mount and 4 large rubber feet for floor use. [. . . ]