User manual PEAVEY LM 16S

[. . . ] Refer servicing to qualified service personnel. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. Before using this appliance, read the operating guide for further warnings. Thank you for purchasing the Peavey IRMTM 8150 mixer amplifier. This is an eight-channel, easy-to-use, powered mixer. [. . . ] Minimum effects signal level is obtained by rotating this control fully counterclockwise. TAPE SECTION: TAPE OUT LEVEL (12) Controls the signal level at the tape out jacks (16). Signal is derived from the main output, but operation is independent of the main master level control (9) and the graphic equalizer (8). TAPE/AUX IN LEVEL (13) When external signals are patched into the tape in jacks (15) or the auxiliary input (25), TAPE/AUX IN LEVEL (13) provides control over the level of signals sent from these inputs to the main mix. 4 TAPE/AUX TO MON (14) Controls the level of tape or AUX IN signal to be sent to the mon. This signal will be mixed with channel monitor signals. TAPE OUT/TAPE IN: CAUTION Before placing connected tape decks in the "record" mode, set the TAPE/AUX IN level control to "0" or off. Most tape decks feed the input signal directly to the output when in record mode. This creates a "closed loop" condition from the tape out to tape in jack which can affect the operational level or sonic quality of the system and cause feedback. TAPE IN (RCA TYPE) JACKS (15) These two jacks provide a paralleled input for proper mono mixing of stereo tape deck outputs. For monaural tape sources, use either jack. TAPE OUT (RCA TYPE) JACKS (16) These two jacks provide the same monaural signal to be supplied to the left and right inputs of a stereo tape deck. POWER AMP INPUT (26) This 1/4" jack provides access to connect external line-level signals to the power amplifier. OPERATION NOTE: This jack permits the internal power amplifier to be switched away from its normal input and to accept external line-level signals. AC POWER AND POWER AMPLIFIER OUTPUT SECTION: FUSE (27) The fuse is located within the cap of the fuseholder. If the fuse should fail, IT MUST BE REPLACED WITH THE SAME TYPE AND VALUE IN ORDER TO AVOID DAMAGE TO THE EQUIPMENT AND TO PRE6 VENT VOIDING THE WARRANTY. If the amp repeatedly blows fuses, it should be taken to a qualified service center for repair. WARNING: THE FUSE SHOULD ONLY BE REPLACED WHEN THE POWER CORD HAS BEEN DISCONNECTED FROM ITS POWER SOURCE. POWER SWITCH (28) Center position is OFF. Two ON positions are provided, one of which will properly ground the amplifier. Switch to the ON side that yields the lowest amount of residual hum or popping noise when the instrument is touched. 220 and 240 volt models have a two-way on/off switch only. LINE CORD (120 V PRODUCTS ONLY) (29) For your safety, we have incorporated a three-wire line (mains) cable with proper grounding facilities. [. . . ] It should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air. This product should not be placed near a source of heat such as a stove, radiator, or another heat producing amplifier. Connect only to a power supply of the type marked on the unit adjacent to the power supply cord. Never break off the ground pin on the power supply cord. [. . . ]