User manual PEAVEY MP 400

[. . . ] Refer to the diagrams in each section to locate each feature by its designated number. Throughout this guide, related features will sometimes refer you to another feature using this number system. Four total input channels Reverb control on each channel Contour high frequency equalizer on each channel 1/4" and XLR inputs on each input channel 1/4" Main Output 1/4" Aux/Reverb Output 1/4" Aux Input 1/4" Remote Switch for reverb defeat Master Three-band Equalizer Master Level and Reverb controls 80 W power amp This section describes the proper application of AC power to your MP 400. To insure the safety of you and your MP 400, please pay close attention to any designated cautions. [. . . ] MAIN OUTPUT 1/4" unbalanced output that can be used as a source for an external amplifier/speaker system feed to other mixers or a tape deck. REVERB/AUX OUTPUT Plugging into this mono (TS) 1/4" output allows you to utilize external effects devices. In order to return the signal from the external effects unit, use the Aux Input (15). Simply turn the Reverb Master down to defeat the Internal Reverb if desired. AUX INPUT Use this mono 1/4"(TS) input to insert a line-level signal into the main mix. This signal can originate from a variety of sources including instrument/mic preamps, external effects (see #14), and even an additional sub mixer. This input bypasses the reverb and can be controlled by the Master EQ and Level. All specifications are typical unless otherwise noted. 778 Volts RMS All specs are referenced to nominal output level (0 dBV) unless otherwise noted. All measurements are wideband 20 Hz to 20 kHz unless otherwise noted. All control settings are nominal (50% rotation) unless otherwise noted. 80 W RMS into 4 ohms 55 W RMS into 8 ohms THD less than . Specifications are subject to change without notice. Specifications are subject to change without notice. What This Warranty Does Not Cover The Warranty does not cover: (1) damage caused by accident, misuse, abuse, improper installation or operation, rental, product modification or neglect; (2) damage occurring during shipment; (3) damage caused by repair or service performed by persons not authorized by Peavey; (4) products on which the serial number has been altered, defaced or removed; (5) products not purchased from an Authorized Peavey Dealer. Who This Warranty Protects This Warranty protects only the original retail purchaser of the product. Speakers, baskets, drivers, diaphragm replacement kits and passive crossovers) and all Accessories Tubes and Meters Duration 2 years *(+ 3 years) 2 years *(+ 1 year) 3 years *(+ 2 years) 1 year *(+ 1 year) 2 years 1 year 90 days [*denotes additional warranty period applicable if optional Warranty Registration Card is completed and returned to Peavey by original retail purchaser within 90 days of purchase. What Peavey Will Do We will repair or replace (at Peavey's discretion) products covered by warranty at no charge for labor or materials. If the product or component must be shipped to Peavey for warranty service, the consumer must pay initial shipping charges. If the repairs are covered by warranty, Peavey will pay the return shipping charges. [. . . ] Unplug this apparatus during lightning storms or when unused for long periods of time. Servicing is required when the apparatus has been damaged in any way, such as powersupply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. If this product is to be mounted in an equipment rack, rear support should be provided. Exposure to extremely high noise levels may cause a permanent hearing loss. [. . . ]