User manual PEAVEY MP 600

[. . . ] A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding plug. The wide blade or third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] Though there are two output jacks, they are mono (parallel) and not stereo. SPEAKER OUTPUTS Two parallel 1/4" jacks are provided at the output of the power amplifier. Each of these input channels are identical. Some features listed below can be found on Channel 7 as well. MIC INPUT XLR balanced low impedance channel input optimized for a microphone or other low impedance source. This connector has +15V phantom power supply on pins 2 and 3 at all times. LINE INPUT 1/4" unbalanced input that accepts line level sources equipped with a 1/4" plug (TS). The two inputs (XLR and 1/4") cannot be used simultaneously. gAIN Sets the level of the individual channel in the mix. REVERB Sets the level to internal reverb from channel and must be used in conjunction with the master reverb level. Channel 7 has two 1/4" line inputs and RCA tape inputs. They add (sum) the left and right signals of a stereo source such as a tape or CD player. LINE AND TAPE INPUTS RCA and 1/4" jacks accept a stereo input from a CD player, tape deck or keyboard. These inputs are summed internally into a mono signal. CAUTION: Care should be taken not to record on a deck that has its outputs connected to the line/tape input jacks and have the Channel 7 Gain control turned up, or Feedback will occur. you may disconnect the tape inputs on the MP 600 if recording on the same tapedeck. Or, you may use a separate tape deck to play and record at the same time. This is the main signal taken after the Master Level (16) and the Master EQ. You may use the ON/OFF single-button switch #0051000. EFFECTS OUTPUT Plugging into this mono (TS) 1/4" output disconnects the internal reverb, allowing you to utilize external effects devices. In order to return the signal from the external effects unit, use the summing inputs of Channel 7. OPERATION NOTE: When using Channel 7 as an effects return, it is important that you turn the Channel 7 Reverb control all the way down ("0" position). [. . . ] Individuals vary considerably in susceptibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. How To Get Warranty Service (1) Take the defective item and your sales receipt or other proof of date of purchase to your Authorized Peavey Dealer or Authorized Peavey Service Center. Include a detailed description of the problem, together with a copy of your sales receipt or other proof of date of purchase as evidence of warranty coverage. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. [. . . ]