User manual PEAVEY NASHVILLE 1000

[. . . ] Nashville 1000 Operating Guide TM Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. Intended to alert the user of the presence of important operating and maintenance (servicing) instructions in the literature accompanying the product. CAUTION: Risk of electrical shock -- DO NOT OPEN!CAUTION: To reduce the risk of electric shock, do not remove cover. [. . . ] It is 10 dB louder than the Low Gain input. (2) Low Gain Low Gain is provided for instruments that have extremely high outputs, which can result in overdriving (distorting) the High Gain input. If both inputs are used simultaneously, the output levels are the same (Both are low gain. ). (3) Pre Gain Pre Gain controls the input level of the Nashville 1000. Adjusting this control clockwise will increase the input level resulting in a hotter, more responsive signal. (4) Pre EQ Patch These 1/4" mono jacks allow for Pre EQ effects patching. Connect a quality shielded instrument cable between the ÒsendÓ jack and the input of your external effects unit. Connect another quality shielded instrument cable from the output of your effects unit to the ÒreturnÓ jack. Pay attention to the external effects unit levels (input and output) to avoid distortion. Consult the ownerÕs manual for your effects unit. It should be noted that too strong a signal at the return jack can overdrive the EQ section of the Nashville 1000. If this happens, the effects unit output should be reduced. (5) Low, Mid, and High EQ This section is an active tone control. Adjusting these knobs clockwise from the center (0) position will amplify the low, mid, or high frequency content. Adjusting counterclockwise from the center (0) position will attenuate the low, mid, or high frequency content. (6) Shift The Shift knob changes the center frequency of the Mid EQ (5), allowing you to tailor the Nashville 1000 EQ to accommodate your tone requirements. The center frequency can be adjusted from 150 Hz to 1. 5 kHz. Keep in mind that the further you turn the knob away from a frequency, the less affect the Mid EQ will have on that frequency. (7) Presence Presence is an active tone control that boosts the extreme high frequencies up to 15 dB. 4 Post EQ Patch (8) Similar to the Pre EQ Patch(4), these jacks are post EQ. The return level should still be monitored for its strength. In addition, the Post EQ Patch can be taken in and out of the signal path via the footswitch. Master Reverb (9) Adjusting this control clockwise will result in more reverb content in the output of the amp. [. . . ] If this product is to be mounted in an equipment rack, rear support should be provided. Exposure to extremely high noise levels may cause a permanent hearing loss. Individuals vary considerably in susceptibility to noise-induced hearing loss, but nearly everyone will lose some hearing if exposed to sufficiently intense noise for a sufficient time. GovernmentÕs Occupational and Health Administration (OSHA) has specified the following permissible noise level exposures: Duration Per Day In Hours 8 6 4 3 2 1 1/2 1 1/2 1/4 or less Sound Level dBA, Slow Response 90 92 95 97 100 102 105 110 115 According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. [. . . ]