User manual PEAVEY NITROBASS

[. . . ] For more information on operation and specifications we suggest that you spend a few minutes to look through this manual. Pay close attention to the safety precautions. They contain warnings that concern the safety of both you and your amp. Compact top box design 450 watts into 2 , 300 watts into 4 , 170 watts into 8 Three-band active EQ with shiftable mid-range control Contour control -10 dB pad switch (active/passive pickup switch) Buffered tuner send jack Footswitchable post-EQ effects loop Electronically balanced XLR jack Pre-/Post-EQ send switch for XLR jack Ground lift switch for XLR jack DDTTM speaker protection with defeat switch Preamp out/power amp in jacks REMOVABLE AC POWER CORD This receptacle is for the IEC line cord (included), which provides AC power to the unit. [. . . ] PRE-/POST-EQ SELECT SWITCH Allows selection between a Pre-EQ (switch set to the "out" position) or a Post-EQ (switch set to the "in" position) send to the XLR line out jack. GROUND LIFT SWITCH Provided to lift the ground on the XLR jack when ground loops are encountered. EFFECTS LOOP REMOTE SWITCH JACK This jack accommodates the remote footswitch (optional part number 00051000 ON/OFF single button switch), which is used to remove the effects loop from the signal path. The remote footswitch essentially acts as a bypass to punch in or punch out from your external effects. DDTTM SPEAKER PROTECTION DEFEAT SWITCH DDTTM speaker protection is defeated when the push button is in the "in" position. We recommend that DDT be enabled at all times to protect the speakers. PREAMP OUT JACK This 1/4" jack is used to route the preamp signal to external inputs, such as the input of an additional power amp. Use of this jack does not defeat the signal to the NitroBass amp (some volume difference may be noticed due to the impedance change experienced when adding an external unit to the signal patch). POWER AMP IN JACK This 1/4" jack is used to input an external signal to the power amp section of the NitroBass. Using this jack will disconnect any signal from the preamp section. Using this jack along with the preamp out jack creates a possible second effects loop. POWER CORD RETAINERS Use the Power Cord Retainers to wrap and store your cable while storing or transporting your NitroBass. It is best to disconnect the cord from the unit before wrapping. SPEAKER OUTPUT JACKS These two 1/4" jacks provide the powered signal from the amplifier. each connector is electrically the same (in parallel). Use one of the jacks to connect your speaker cabinet and the other to add a second speaker cabinet in parallel. The minimum speaker load impedance is 2 ohms (or two 4-ohm speakers in parallel). Warning: To prevent the amplifier from overheating, the front fan and rear-located vents should always remain clear of obstructions. [. . . ] refer all servicing to qualified service personnel. Servicing is required when the apparatus has been damaged in any way, such as powersupply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped. If this product is to be mounted in an equipment rack, rear support should be provided. Exposure to extremely high noise levels may cause a permanent hearing loss. [. . . ]