User manual PEAVEY PV 14

[. . . ] Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, this apparatus should not be exposed to rain or moisture, and objects filled with liquids, such as vases, should not be placed on this apparatus. Before using this apparatus, read the operating guide for further warnings. [. . . ] Mute The mute button is a quick way to remove the channel signal from the left/right main mix, as well as effects and monitor sends, without disturbing the control settings. Clip/Mute LED This light normally indicates that the channel signal level is nearing the overload point, but it also lights when mute is engaged. When it lights, roughly 3 dB of headroom remains. Signal LED The signal LED lights when the channel level reaches approximately -20 dBu. This not only indicates which channels are active, but also serves as a mini level meter. Fader The channel Fader is the channel output control, which sets the signal level to the left and right mix and the effects send control. CLIP 3 7 Tape In/Out 17 8 2 16 EFX SIGNAL 1 9 DEFEAT The tape input jacks are designed to accommodate tape, CD, 0 10 or computer sound card output levels. The output level is +4 HEADPHONE dBu for connecting to a recorder or sound card input. The tape inputs can be used as an additional stereo input by engaging the Tape/USB to Main Mix switch (27). The tape input can also be used to monitor the recorder/sound card output without the risk of feedback. If another device is connected to the Tape Input, this signal will be combined with the USB input signal. Medium Concert Hall Larger Concert Hall Darker Intimate Room Bright Larger Room Darker Bright Darker Large Space, Long and Darker Classic Spring Single Delay (Slap-back) Warm Delay with Repeats Dark Delay with Repeats Warm Delay Single Delay, 30-120 ms Warm Delay with Modulation Brightens and Adds Room Reverb Brightens and Adds Spring Reverb Green Signal LED and Red Clip LED The green Signal LED and red Clip LED are used to set the operating input level to the PVTM10, PVTM14, and PVTM20 effects processors. the signal level to the processor is affected by channel Fader , the Effects Send and the Effects Send Master Controls. Start with the Master Control (20) set to 0 (12 o'clock) and adjust the channel sends so that the signal LED lights and the clip LED blinks on occasionally, if at all. The clip LED lights 6 dB below clipping. pressing the EFX defeat mutes the effects signal and lights the clip/mute LED. EFX Return Once the input level is set (see 17) use the EFX Return control to mix the effects processor output into the main left/right outputs. Remember, a little reverb goes a long way. MON Send Master This is the master output level control for the monitor mix. The output level sent to the Monitor Send jack (37) is controlled by the channel Monitor Send controls (6) and by this master control. EFX Send Master This is the master output level control for the EFX mix. The output level sent to the EFX Send jack and the internal effects processor is controlled by the channel Fader (12), the channel EFX Send controls (7), and by this master control. [. . . ] The MON mix is determined by the amount of signal being sent to the MON bus in each channel and by the Monitor Master control (19). eFX Send The EFX Send features a 1/4" TRS Z-balanced jack in the master section. (3) The wire that is colored brown must be connected to the terminal that is marked with the letter L or colored red. USB port and USB Record Level Control The USB port is used to connect the PVTM Series USB mixer to acomputer for recording or playing back digital audio to/from your computer. [. . . ]