User manual PEAVEY SANCTUARY SSE 15 DATASHEET

[. . . ] The highs are generated using the highly acclaimed Peavey 14XT titanium compression driver. The Sound Guard IV tweeter protection network is built in for driver protection. [. . . ] (1) 1/4"-20 threaded mounting point on back bottom for angle adjustments. (4) 1/4"-20 threaded mounting points on bottom to accommodate use of VersamountTM 70 adjustable mounting bracket. DO NOT suspend this unit upside down using VersaMountTM system. loudspeaker system's power handling using a full-range form of the AES Standard 2-1984. Using audio band 20 Hz to 20 kHz pink noise with peaks of four times the RMS level, this strenuous test signal assures the user that every portion of this system can withstand today's high technology music. This rating is contingent upon having a minimum of 3 dB of amplifier headroom available. Harmonic distortion Second and third harmonic distortions vs. frequency are plotted in figures 5 & 6 for two power levels. Ten percent (10%) of rated input power and either one percent (1%) of rated input power or 1 Watt, whichever is greater. Distortion is read from the graph as the difference between the fundamental signal (frequency response) and the desired harmonic. As an example, a distortion curve that is down 40 dB from the fundamental is equivalent to 1% distortion. Directivity factor, Q (Mean): 10. 86 ± 6. 7 Directivity index, Di (Mean): 9. 57 dB ± 2. 6 dB Transducer complement: Low frequency section: Peavey Scorpion® Pro 1500+ woofer with 2. 5" (64 mm) voice coil High frequency section: Peavey 14XTTM titanium diaphragm compression driver on a 90° x 40° constant directivity horn Box tuning frequency: Low frequency section: 74 Hz Dimensions (H x W x D): Front: 27" x 18" x 17. 75" 686 mm x 467 mm x 451 mm Rear: 27" x 12. 14" x 17. 75" 686 mm x 308 mm x 451 mm Mounting Caution: Before attempting to suspend or mount this speaker, consult a certified structural engineer. The speaker may fall due to improper installation, resulting in serious injury and property damage. DO NOT suspend or mount any other product or device from this enclosure. All associated rigging is the responsibility of others. Net Weight: 46 lbs. [. . . ] The blending of the components of the SSE 15 exhibit a desirable beamwidth and directivity (figures 3 & 4) suitable for sound reinforcement applications. Electro-acoustic crossover frequency (internal passive): 2. 8 kHz Impedance (Z): Full range: Nominal: 8 Minimum: 5. 4 Input Connection: One (1) four-pin Neutrik Speakon in parallel with one (1) two-position terminal strip ® ® 3 + 2 YEAR LIMITED WARRANTY NOTE: For details, refer to the warranty statement. Copies of this statement may be obtained by contacting Peavey Electronics Corporation, P. O. [. . . ]