User manual PEAVEY SRC 4026 FC

[. . . ] Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. Before using this appliance, read the operating guide for further warnings. [. . . ] Selects which outputs will have the talkback mic signal (L-R or AUX 1-4) for house or monitor feeds. This affects the feed to the L-R and AUX 1-4. Sets the level of the PFL mix that is sent to the headphone/control room level control. This LED illuminates when the PFL is active and its signal is overriding the standard L-R mix in the headphone and control room outputs and at the L-R meters. The signals that are present in the PFL mix can be seen by the individual LEDs lit. The output changes from the L-R mix (post fader) to the PFL mix whenever the PFL is active. It is unbalanced, and can be used to feed an external monitor system or effect unit. The level is set by the AUX Master Level (#26) and the individual channel level control (see #10, 11). The left/mono input supplies signal to both the left and right inputs if there is no input connected to the right input jack. It is unbalanced, with its output level set by the sub fader (#35). 1/4" stereo (TRS) jack which allows an external device to be inserted into the signal path before the sub fader. Input connector for a low-impedance, balanced microphone used for house or stage communication. Phantom power is not available at this connector. It changes from the L-R mix to the PFL mix when the PFL is active. 1/4" left and right unbalanced outputs of the headphone mix to feed the control room monitor amps. The level is set by the master left and right right faders (#36). 1/4" stereo (TRS) jack which allows an external device to be inserted into the signal path before the Master L/R Fader. The power on LED indicator will light when the unit is powered. Connect the line cord to this connector to provide power to the unit. Damage to the equipment may result if improper line voltage is used. For your safety, we have incorporated a 3-wire line (mains) cable with proper grounding facilities. It is not advisable to remove the ground pin under any circumstances. [. . . ] Never break off the ground pin on the power supply cord. For more information on grounding, write for our free booklet "Shock Hazard and Grounding. Power supply cords should always be handled carefully. Never walk or place equipment on power supply cords. [. . . ]