User manual PEAVEY TRANSTUBE 100 EFX

[. . . ] For more information on other great Peavey products, go to your local Peavey dealer or online at www. Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. [. . . ] GROUND POLARITY SWITCH This three-position rocker switch should normally be placed in the center (0) position. If hum or noise is noticed coming from the speaker enclosure(s), the switch may be placed in the "+" or "-" position to minimize hum and noise. If changing the polarity does not alleviate the problem, consult your authorized Peavey dealer, the Peavey factory, or a qualified service technician. The mains cord should be connected to the amplifier before connecting to a suitable AC outlet. Pressing the MODE SWITCH (28) selects between the two modes. PRESET SELECT MODE In this mode, all three switches control effects presets. Their corresponding LEDs indicate which preset is active. Once desired settings are achieved utilizing the effects controls on the front panel, double-click one of the Preset switches (30, 33, or 35) to store the settings. To return to the last saved settings for a Preset, press the desired Preset switch once. For a detailed explanation on creating and storing presets, refer to the TWEAK FEATURES section of this manual on the following page. EFX SELECT MODE NOTE: When entering this mode, the current preset will remain active. In this mode, SWITCH 1 (30) selects between the Lead and Clean channels. the CHANNEL LED (31) will illuminate when the Lead channel is active. SWITCH 2 (33) toggles between two effects and their respective settings. This switch may be used as an on/off switch if one of the settings has no effects active. To use the MODULATION LED (32) as a status indicator, the "off" (or lower setting) should be made with the LED dark, and the "on" (or higher setting) made with the LED illuminated. sWITCH 3 (35) toggles between two reverb and delay settings. As with effects settings, this switch may be used as an on/off for reverb and delay. Both functions change simultaneously when this switch is depressed. In addition to the adjustments described in the EFX ADJ PARAMETERS section of this manual, additional tweaks may be made to customize effects to user preference. Tweaks are made by pressing and holding the EFX ADJUST (12) control while simultaneously rotating the REVERB (13) control. The EFX ADJUST control must be pressed for at least one second to enter Tweak Mode. [. . . ] The unit has been dropped or the enclosure damaged. The user should not attempt to service this equipment. All service work should be done by a qualified service technician. This product should be used only with a cart or stand that is recommended by Peavey Electronics. [. . . ]