User manual PEAVEY TRANSTUBE 110 EFX

[. . . ] For more information on other great Peavey products, go to your local Peavey dealer or online at www. Intended to alert the user to the presence of uninsulated "dangerous voltage" within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, do not expose this appliance to rain or moisture. [. . . ] This switch allows you to instantly change the voicing to reflect the tones of modern and vintage amplifiers. the MODERN position maintains a warm , standard voicing. The VINTAGE position changes the overall function of the EQ and adds a hint of brightness to emulate some classic amp designs. Experiment with this switch, along with the EQ (11) adjustments, to capture your desired tone. You may refer to the Recommended Settings on page 6 for some creative starting points. Rotating this control clockwise changes the parameter of the active effect according to the descriptions below. EFX amps are built with factory settings loaded into the presets. To return to the factory settings, press and hold both the EFX ADJUST (14) and DELAY (16) controls while turning the amp on. Three types of delay are available: SLAP (1 repeat), ECHO (3 - 4 repeats), or INFINITE (5 - 6 repeats). The LEDs in each section of the control indicate which type is active and volume level. Pressing the control twice sets the delay time to interval between presses. Pressing the MODE SWITCH (18) selects between the two modes. NOTE: When entering this mode, the current preset will remain active. In this mode, PRESET 1 (20) selects between the Lead and Clean channels. the CHANNEL LED (21) will illuminate when the Lead channel is active. PRESET 2 (23) toggles between two effects and their respective settings. This switch may be used as an on/off switch if one of the settings has no effects active. To use the MODULATION LED (22) as a status indicator, the "off " (or lower setting) should be made with the LED dark, and the "on" (or higher setting) made with the LED illuminated. pRESET 3 (25) toggles between two reverb and delay settings. As with effects settings, this switch may be used as an on/off for reverb and delay. [. . . ] This block diagram shows signal flow within the unit. In order to thoroughly understand the unit's functions, please study the block diagram carefully POWER AMP SECTION: Rated power and load: 40 Watts (RMS) into 6 Ohms Power @ clipping (typically): (5% THD, 1 kHz, 120 VAC line) 35 Watts (RMS) into 6 Ohms Total harmonic distortion: Less than 0. 5% THD, 100 mW to 15 Watts (RMS), 100 Hz to 10 kHz Power amp hum and noise @ nominal input level: (20 Hz to 20 kHz, unweighted) Greater than 82 dB below rated power Power Consumption: 75 Watts 50/60 Hz, 120 VAC PREAMP SECTION: The following specs are measured @ 1 kHz with the controls preset as follows: Channel select: CLEAN EQ voicing switch: MODERN Low, mid, and high: 5 Pre gain and post gain: 10 Efx adjust: OFF Reverb: OFF Delay: OFF Volume (nominal level): 5 Volume (minimum level): 10 Preamp input (clean channel): Impedance: High Z, 250 k Ohms Nominal input level: -14 dBV, 200 mV (RMS) Minimum input level: -24 dBV, 64 mV (RMS) Effects send: Output impedance: 1k Ohms Nominal output Level: -7. 4 dBV , 425 mV (RMS) Effects return: Input impedance: 31 k Ohms Nominal input level: -7. [. . . ]