User manual PEAVEY TRANSTUBE 258 EFX

[. . . ] A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding plug. The wide blade or third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] The Pre Gain can be used to control the distortion level in the Lead channel. To obtain more distortion simply increase the Pre Gain and set the Post Gain (9) to the desired volume level. pOST GAIN Controls the overall volume level of the Lead channel. The final level adjustment should be made after the desired sound has been achieved. The VINTAGE position changes the overall function of the EQ and adds a hint of brightness to emulate some classic amp designs. Experiment with this switch, along with the EQ (11) adjustments, to capture your desired tone. You may refer to the Recommended Settings on page 6 for some creative starting points. Rotating this control clockwise changes the parameter of the active effect according to the descriptions below. EFX amps are built with factory settings loaded into the presets. To return to the factory settings, press and hold both the EFX ADJUST (14) and DELAY (16) controls while turning the amp on. Three types of delay are available: SLAP (1 repeat), ECHO (3 - 4 repeats), or INFINITE (5 - 6 repeats). The LEDs in each section of the control indicate which type is active and volume level. Pressing the control twice sets the delay time to interval between presses. Pressing the MODE SWITCH (17) selects between the two modes. EFX SELECT MODE NOTE: When entering this mode, the current preset will remain active. In this mode, PRESET 1 (19) selects between the Lead and Clean channels. the CHANNEL LED (20) will illuminate when the Lead channel is active. PRESET 2 (22) toggles between two effects and their respective settings. This switch may be used as an on/off switch if one of the settings has no effects active. To use the MODULATION LED (21) as a status indicator, the "off" (or lower setting) should be made with the LED dark, and the "on" (or higher setting) As with effects settings, this switch may be used as an on/off for reverb and delay. Both functions change simultaneously when this switch is depressed. PRESET SELECT MODE In this mode, all three switches control effects presets. [. . . ] If the repairs are covered by warranty, Peavey will pay the return shipping charges. How To Get Warranty Service (1) Take the defective item and your sales receipt or other proof of date of purchase to your Authorized Peavey Dealer or Authorized Peavey Service Center. Include a detailed description of the problem, together with a copy of your sales receipt or other proof of date of purchase as evidence of warranty coverage. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. [. . . ]