User manual PEAVEY TRIPLE XXX 40-EFX

[. . . ] For more information on other great Peavey products, go to your local Peavey dealer or online at www. Intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. CAUTION: To reduce the risk of electric shock, do not remove cover. WARNING: To prevent electrical shock or fire hazard, this apparatus should not be exposed to rain or moisture, and objects filled with liquids, such as vases, should not be placed on this apparatus. [. . . ] EFX amps are built with factory settings loaded into the presets. To return to the factory settings, first turn the power to OFF. Then, press and hold both the EFX ADJUST (24) and DELAY (26) controls while turning the amp back on. Three types of delay are available: SLAP (1 repeat), ECHO (3­4 repeats), or INFINITE (5­6 repeats). The LEDs in each section of the control indicate which type is active and level. Pressing the control twice sets the delay time to the interval between presses. This fuse must be replaced with one of the same type and value to avoid damaging the amplifier and voiding the warranty. If the amp repeatedly blows the fuse, it should be taken to a qualified service center for repair. Warning: The fuse should only be replaced after the power cord has been disconnected. (28) Ground Polarity Switch This three-position, rocker-type switch should normally be placed in the center (0) position. If hum or noise is noticed coming from the speaker enclosure(s), the switch may be placed in the "+" or "-" position to minimize hum/noise. If changing the polarity does not alleviate the problem, consult your authorized Peavey dealer, the Peavey factory or a qualified service technician. (29) Remote Switch (Triple XXX® 40 only) This 1/4" connector is provided for the connection of the remote footswitch. The footswitch cable should be connected before the amp is powered up. A high damping factor (TIGHT) reduces cone vibration quicker than a low (LOOSE) factor. This switch works much like the resonance and presence controls on other Peavey amps, if those controls were turned simultaneously. if the DAMPING SWITCH is changed , the volume of the amp will also change and require re-adjustment. (32/33) Effects Send/Return These 1/4" mono (TS) jacks allow signal to be sent to, and returned from, external effects and/or signal processors. Using shielded cables with 1/4" mono (TS) phone plugs, patch from EFFECTS SEND to the input of the external device and from the output of the external device to EFFECTS RETURN. Only devices that do not increase signal gain should be used in this effects loop (chorus, delay, reverb, etc. The footswitch cable should be connected before the amp is powered up. (35) Channel Select Button Depressing this button allows you to switch between the Ultra and Rhythm channels. [. . . ] The footswitch cable should be connected before the amp is powered up. A high damping factor (TIGHT) reduces cone vibration quicker than a low (LOOSE) factor. This switch works much like the resonance and presence controls on other Peavey amps, if those controls were turned simultaneously. if the DAMPING SWITCH is changed , the volume of the amp will also change and require re-adjustment. [. . . ]