User manual PEAVEY UA 35T II

[. . . ] This feature is internally defeatable when required. Twenty-five and seventy volt line output capability is standard equipment, and the unit is packaged for shelf or wall mounting convenience. The user-friendly control layout, coupled with state-of-the-art circuit design, ensure reliable long-term operation and smooth trouble-free installation. FEATURES ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ ¥ 35 watts into 4 ohms Mic/page inputs (screw terminals) Mic/page select switch Dedicated program input (screw terminals and RCA jacks) Bass and treble controls Mic/page level control AUX level control Direct 4 ohms output (screw terminals) Completely isolated 8 ohms, 25 volt, and 70 volt outputs (screw terminals) Shelf-top or wall-mountable chassis WALL OR SHELF MOUNTING The UA 35T II can be mounted on a vertical or horizontal surface using the brackets formed on the bottom panel. [. . . ] Connect only to proper source--see back panel markings. POWER SWITCH (12) Used to turn AC mains power on or off. 12 11 10 BLOCK DIAGRAM Barrier Strip GND 4W COM 8W 25V 70V Mic/Page Barrier Strip Mic/Page Selector Switch DDT Sense u Sm EQ M AP Level Aux 1 Muting Transformer Barrier Strip Level 3 WIRING DIAGRAM OUTPUTS 35 W RMS GND 4W COM 8W 25V 70V (12V) (17V) 70V ÒConstant VoltageÓ Distribution System UA 35T Specifications OUTPUT POWER: 35 watts RMS INPUT SENSITIVITY: Aux Input: 100mV @ 10K ohms Mic Input: 1mV @ 1K ohms Page Input: 120mV @ 5K ohms POWER BANDWIDTH: Aux Mic Page Aux Mic Page Aux Mic Page 50 Hz - 20 kHz . 6% THD 50 Hz - 20 kHz . 8% THD 50 Hz - 20 kHz . 6% THD 50 Hz - 20 kHz +0, -2 dB 50 Hz - 20 kHz +0, -2 dB 50 Hz - 20 kHz +0, -2 dB <. 05% <. 2% <. 2% OUTPUTS: 4 ohms, 8 ohms, 25 V, 70 V FREQUENECY RESPONSE: OUTPUT REGULATION: Less than 0. 5 dB, no load to full load CONTROLS: 1 Aux input gain control, 1 mic/page gain control, 1 bass control, 1 treble control, 1 mic/page select switch THD (1 kHz): INDICATORS: Power LED S/N RATIO (22 kHz BW): Tone controls flat/input control max Aux 85 dB (50 ohm input) Mic 58 dB (150 ohm input) Page 58 dB (680 ohm input) PROTECTION: Built-in, with AC line fuse POWER CONSUMPTION: 120 volts AC, 60 Hz, 100 watts DIMENSIONS: 4. 25" H x 8. 25" W x 13. 625" D TONE CONTROLS: Bass +/- 10 dB @ 100 Hz Treble +/- 10 dB @ 10 kHz WEIGHT: 11. 5 pounds INPUTS: Aux Input: Dual RCA phono jacks, summed Mic/Page Input: Screw terminal input switchable between mic/page COLOR: Gray OTHER FEATURES: Mic/page input has precedence over the Aux input (defeatable) 4 IMPORTANT SAFETY INSTRUCTIONS WARNING: When using electric products, basic cautions should always be followed. Read all safety and operating instructions before using this product. All safety and operating instructions should be retained for future reference. Obey all cautions in the operating instructions and on the back of the unit. All operating instructions should be followed. This product should not be used near water, i. e. , a bathtub, sink, swimming pool, wet basement, etc. This product should be located so that its position does not interfere with its proper ventilation. It should not be placed flat against a wall or placed in a built-in enclosure that will impede the flow of cooling air. This product should not be placed near a source of heat such as a stove, radiator, or another heat producing amplifier. Connect only to a power supply of the type marked on the unit adJacent to the power supply cord. Never break off the ground pin on the power supply cord. For more information on grounding, write for our free booklet ÒShock Hazard and Grounding. " 7. Power supply cords should always be handled carefully. Never walk or place equipment on power supply cords. [. . . ] GovernmentÕs Occupational Safety and Health Administration (OSHA) has specified the following permissible noise level exposures. Duration Per Day In Hours Sound Level dBA, Slow Response 8 90 6 92 4 95 3 97 2 100 1 1/2 102 1 105 1/2 110 1/4 or less 115 According to OSHA, any exposure in excess of the above permissible limits could result in some hearing loss. Ear plugs or protectors h1 the ear canal]s or over the ears must be worn when operating this amplification system in order to prevent a permanent hearing loss if exposure is in excess of the limits as set forth above. [. . . ]