User manual PEAVEY XXL 212

[. . . ] A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding plug. The wide blade or third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] VOLUME This control, on all three channels, sets the overall level of its respective channel. GAIN This control, on both the Ultra and Lead channels, controls the input volume level of its respective channel. HIGH This passive control, on both the Clean and Lead channels, regulates the high frequency response of its respective channel. MID This passive control, on both the Clean and Lead channels, regulates the mid frequency response of its respective channel. LOW This passive control, on both the Clean and Lead channels, regulates the low frequency response of its respective channel. Lead channel activation illuminates the yellow LED, and Clean channel activation illuminates the green LED. CHANNEL This three-position toggle allows selection between the XXL 212 COMBO's three channels. cHANNEL ACTIVATION LEDs (16) indicate which channel is active. Channel switching can also be accomplished from the included footswitch. see the FOOTSWITCH section of this manual for explanation of switch operation. The CHANNEL switch must be set in the ULTRA position in order for the footswitch to operate properly. The footswitch cable should be connected before the amp is powered up. 3V RMS) when "out" and 0 dBV (1 V RMS) when "in. PREAMP OUT The preamp out can be used to route the amplified signal from the preamp to a mixing console, tape recorder, etc. Connect the preamp output to line-level inputs of other equipment using high quality shielded cable. This patch does not affect operation of the amplifier. pOWER AMP IN Used to connect line-level signals to the XXL 212 COMBO's power amplifier section. Connect the power amp input to line-level output of other equipment using high quality shielded cable. This patch disconnects the XXL 212 COMBO preamp section from the power amp section. A higher damping factor (TIGHT) reduces cone vibration more quickly than a lower damping factor (LOOSE). This switch works much like the Resonance and Presence controls found on other Peavey amps, if they were to be turned simultaneously. If the Damping switch is changed, the volume level of the amp will also change and may require re-adjustment of the Master Volume (3). [. . . ] If the repairs are covered by warranty, Peavey will pay the return shipping charges. How To Get Warranty Service (1) Take the defective item and your sales receipt or other proof of date of purchase to your Authorized Peavey Dealer or Authorized Peavey Service Center. Include a detailed description of the problem, together with a copy of your sales receipt or other proof of date of purchase as evidence of warranty coverage. Some states do not allow limitations on how long an implied warranty lasts, so the above limitation may not apply to you. [. . . ]