User manual PEG PEREGO BOOK CROSS

[. . . ] To complete the operation, press the two side buttons on the handle (Fig_c) to ensure the handle pushes in all the way, until it clicks into place (Fig_d). 4 FITTING THE BASKET: if lowered, lift the basket tube to the horizontal position. Press the silver buttons under the metal basket tube located at the back of the stroller (fig_a) and remove the metal tube (fig_b). Thread the tube through the fabric loop on the back of the basket, making sure that the two silver buttons are facing downward (fig_c). [. . . ] The hood may be pulled forward into several positions (fig_d). 13 ADJUSTING THE BACKREST: to lower the backrest, press the clip and the backrest will move down to the desired position. To raise the backrest, press the clip and lift the backrest to the desired height. 14 FIVE POINT SAFETY HARNESS: To fasten it, push the two waist strap buckles (with the shoulder straps attached – arrow_a) into the leg divider until they click into place (arrow_b). To unfasten it, press the round button in the centre of the buckle (arrow_c) and pull the waist straps out (arrow_d). 15 To tighten the waist strap, pull on both sides in the direction of the arrow (arrow_a). To loosen it, move it in the opposite direction. 16 Before adjusting the height of the safety harness remove the shoulder pads (fig_a). To adjust the height, slip the belts through the eyelet in the fabric (fig_b) and position them in the most suitable eyelet. 17 FOLDING UP: To fold up the stroller, you must ensure the front wheel swivels and the hood are closed, when fastened. Place the handle as shown in the figure (fig_a). Pull the inside handle on the base (fig_b) and lift it (fig_c); the handle will drop forward until the frame is closed. 1 8 To close correctly, check the side hook is inserted (fig_a). If not automatically locked, compress the chassis slightly. When folded, the stroller will free standing (fig_b). 1 9 For greater compactness , it is possible to remove the wheels. Remove the rear wheels: pull the pivot To outwards and remove the wheel as shown in the figure (fig_a). To remove the front wheels: press the tab as shown, and remove the wheel (fig_b). TRANSPORT: the stroller can be carried comfortably locking the front wheels and grasping the main handle (fig_c). 20 REMOVABLE ITEMS: to remove the hood, take the elastic off from the buttons on the inside - 14 - of the handlebar (fig_a), detach the press studs the sides of the chassis (fig_b), detach the Velcro strip from the backrest (fig_c) and remove the attachments of the hood from their positions on the chassis (fig_d). 21 To remove the seat fabric, press in the holes on the inside of the chassis (fig_a); remove, from the side of the seat, the rigid flap of the chassis fabric ((fig_b), unfasten the elastic of the net from the side buttons inside the handlebar (fig_c) and unfasten the elastics from the buttons inside the chassis (fig_d). 22 From the front, remove the lining from the foot platform (fig_a), remove the leg divider strap from under the seat (fig_b), unbutton the seat fabric (fig_c), unscrew the waist belt on the side (fig_d) and remove the seat fabric from the backrest (fig_e). [. . . ] Do not use solvent or similar cleaning products; keep all metal parts dry to prevent rusting; keep moving parts clean (adjustment mechanisms, locking mechanisms, wheels, . ) and free of dust and sand and, if necessary, lubricate with light machine oil. CLEANING THE RAIN CANOPY: wash with a sponge and soapy water; do not use detergents. CLEANING FABRIC PARTS: brush fabric parts to remove dust and wash by hand at a maximum temperature of 30°C; do not wring; do not use chlorine bleach, do not iron; do not dry clean; do not apply solvent-based stain removers and do not dry in a tumble dryer. [. . . ]