User manual PEG PEREGO PRAMETTE PLIKO P3

[. . . ] ASSEMBLYING THE STROLLER 4• To mount the front wheels, lower Lever A and slip the wheels onto the axle, as shown in the figure. Press until the wheels click into place. 5• To assemble the rear wheels fasten the wheels connected by the break wire, as indicated in the figure. 6• Carefully distinguish the left wheel from the right, to fasten the two rear wheels properly. [. . . ] To lower it, press the button as you lower the handle. REAR LEDGE 24• The rear ledge helps overcome small rises and can also be used to carry a second child. LOADING SEQUENCE 25• To use the stroller with two children, brake the stroller, place the smaller child in the seat and fasten the safety belt (1). Grip the handles (2) and help the second child climb onto the footrest (3). Do not allow the child to climb onto the rear footrest when the stroller is empty. STROLLER-BABY CARRIAGE 26• Pliko P3-Pramette is the new stroller with a baby carriage incorporated. With a flick of your hand, you can turn the stroller into a baby carriage, and back again. €¢ The hood, thanks to its reversible attachment system, can also be installed on the part by the handles when in the stroller version (A) or on the part opposite the handles when in the carriage version (B). Before removing the hood to turn it around, close it and bring it right forward to rotate the fasteners, then detach it and reinstall it on the opposite part; you can even rotate the fasteners with your hands. €¢ The hood comes with a zipper, to make it easy to attach products from our accessory line, such as the rain canopy and the mosquito netting. €¢ The Pliko P3-Pramette cover can be mounted on the same side as the footboard for the stroller version (A), and on the same side as the backrest for the baby carriage version (B). VERSION “A” - STROLLER (PLIKO P3) 27• To mount the hood on the stroller, place it on the same side as the handles and push the tabs downwards, as shown in the figure. (Turn the hood attachment to adjust it for mounting the hood on the stroller). 28• To extend the hood, push the brace downwards. The hood can be reclined along with the backrest. 29• To mount the cover, zip it onto the footboard as shown in the figure. REMOVING THE HOOD 30• To remove the hood, you must unbutton it from the stroller, loosen the couplings and raise the tabs of the fasteners, pushing towards the inside of the stroller. VERSION “B” - BABY CARRIAGE (PRAMETTE) 31• To turn the stroller into a baby carriage, remove the hood and the cover if they have been mounted. Lift the footboard to its highest position. Place the front bar in the second position, and make sure the safety belts are attached to the backrest by inserting the tab through the special holder in the sack. 32• Unbutton the tab buttons, as indicated in the figure from the backrest sack and lower as indicated in figure. 33• Unzip the two zippers found on the top of the backrest and fold the sack as indicated in the figure. [. . . ] GANCIOMATIC SYSTEM The Ganciomatic System is the swift, practical system that allows one to fasten to the stroller, with Ganciomatic fasteners, the car seat Primo Viaggio, which can be bought separately and is also equipped with Ganciomatic System. Primo Viaggio can be detached from its base (which stays in the car) and attached to the Ganciomatic fasteners of the stroller to transport your child without disturbing him/her. STROLLER GANCIOMATIC HOOKS 60• To raise the Ganciomatic hooks on the stroller, pull the sack up at the corners of the seat and turn the two hooks upwards until they click into place. 61• To lower the Ganciomatic hooks on the stroller, pull the little lever outwards and turn the hooks upwards at the same time, as shown in the figure. [. . . ]