User manual PEG PEREGO PRIMA PAPPA DONDOLINO

[. . . ] Please note any observations or suggestions you may have on the questionnaire. iNSTRUCTIONS FOR USE ASSEMBLING THE HIGH CHAIR 1· When mounting the rockers on the high chair, take care to position the right and the left rocker correctly, placing the exterior side of the rocker on the outside. The exterior side of the rocker has holes on the ends for the screw heads. 2· The figure shows the correct position for the rockers on the high chair. [. . . ] A), and fasten the buckle to the peg, pulling the safety belt until it clicks into place (fig. 7 HEIGHTS The high chair adjusts to 7 different heights. 20· To lift the high chair, hold it under the tray and pull upwards. 21· To lower the high chair, simultaneously press the two side buttons, stopping at the desired height. These operations can be carried out with the child in the high chair. rECLINING HIGH CHAIR 22· The high chair reclines, and adjusts to four different positions: for mealtime, playtime, relaxing, or napping. To adjust it, lift the handle behind the backrest and set the high chair to the desired position. This operation can be carried out with the child in the high chair. tO FOLD THE HIGH CHAIR 23· To close the tray, turn the knob under the tray counterclockwise, and pull the tray out as far as the red markers shown with the arrows in the figure. Lower button number 2 while lifting the tray (fig. Figure B shows the tray in the closed position. 26· Move the high chair seat to the lowest position by pressing the side buttons. Lift the handle on the back of the high chair (fig. To open the high chair, push the red side levers downwards, pressing on the rear frame as shown in figure 8. To remove the high chair cover, remove the safety belt from under the chair and the backrest. 30· Lower the high chair completely, and unbutton the cover from the sides of the backrest. To fold the high chair back up into its "packing position" (for transporting it or storing it in its box): - Remove the tray. A small screwdriver is necessary for this step. Press the side button while slipping the screwdriver into the slit. Repeat the same operation, pushing the screwdriver to the left and lowering the high chair to the lowest position (the position in which it cannot be used). Fold the high chair up and place it in its box. iNSERTING THE BATTERIES Batteries ARE NOT SUPPLIED with the high chair. [. . . ] Be sure to keep all moving parts clean, lubricating them with light oil if necessary. Dry off metal parts to prevent rusting. Regularly clean the plastic parts with a damp cloth. Remove any dust and sand from the wheels. [. . . ]