User manual PEG PEREGO TRIO PLIKO SWITCH COMPACT

[. . . ] E N• Spare parts available in different colours to be specified when ordering. Com _ IMPORTANT: read these instructions carefully and keep them for future use. The child’s safety could be at risk if these instructions are not followed. _ This item was designed for the transport of 1 child in the seat and 1 one child standing on the rear footboard. [. . . ] 1 2• By lowering the stroller backrest, the rear hood extends and through the double zipper a window can be created to allow more air to circulate and watch the child when sleeping. 1 3• COVER: for complete Pliko P3 Compact: To put the apron on the pushchair, do up the buttons on both sides and under the footrest (Fig. Pull the cover upwards so that it covers the bumper bar (Fig. Some models have a muff as well, so putting on the cover may be a little different (Fig. 1 4• RAINCOVER: for complete Pliko P3 Compact: to fit the rain canopy, extend it over the stroller and snap fit the buttons on both sides of the hood (Fig. Fasten the elastic loops including the chassis in the lower part of the stroller (Fig. € Do not use the rain canopy indoors and always make sure that the child is not too hot. € Do not place the rain canopy near heat sources and pay attention to cigarettes. € Make sure that the rain canopy does not interfere with any moving mechanism of the stroller. € Always remove the rain canopy before folding up the stroller. 1 5• 5-POINT SAFETY HARNESS: to fasten, insert the two buckles of the waist strap (with attached shoulder straps, arrow a) into the leg divider strap until they click into place (arrow b). To unfasten them, press the button which is situated in the centre of the fastener (arrow c) and pull the waist strap outwards (arrow d). 1 6• To tighten the waist strap, pull on both sides in the direction of the arrow (Fig. The waist strap can be tightened as far as the safety lock (Fig_b). 1 7• To adjust the height of the safety harnesses, release the two buckles on the rear of the backrest. Pull the shoulder straps towards you (arrow a) until the buckles are released and insert them in the backrest loops (arrow b). Remove the shoulder straps from the sack (arrow c) and insert them in the most appropriate buckle (arrow d), then reattach the two buckles behind the backrest (arrow e). The buckles are securely attached when a click is heard (fig f). 1 8• ADJUSTING THE FOOTREST: the footrest can be adjusted to three positions. To lower the footrest, pull the two side levers downwards while lowering the footrest. To lift the footrest, pull it upwards until it clicks into place. 1 9• ADJUSTING THE BACKREST: the backrest reclines to four different positions. [. . . ] Position the backrest with the cover on the chassis seat (fig_b). 3 4• To attach the backrest to the chassis (fig_a) insert the two ends, pressing the two buttons, into the chassis seat, as shown in figure 1, until they click into position, as shown in figure 2. To attach the back adjustment bar to the chassis (fig_b), rotate the attachment upwards (figure 2, as shown by the arrow) and position it behind the rear upright. € Push the two fasteners down until they click into position in the seats in the rear uprights (fig_c). [. . . ]