User manual PEG PEREGO VIAGGIO1

[. . . ] E N• The "Viaggio1 Duo-Fix" car safety seat is attached to the car using a three-point seat belt. E N• The “Viaggio1 Duo-Fix” car seat is secured in vehicles with the ISOFIX system. See the “Isofix Base 0+1” instruction manual for the vehicle installation procedure. Se brugsanvisningen for "Isofix Base 0+1" for anvisninger på, hvordan den spændes fast i bilen. [. . . ] Fasten the belt, ensuring that it clicks into place. 5• The figure shows Viaggio1 Duo-Fix fitted in a vehicle. 6• Check that the lap belt has gone through the low slots marked in red and tighten it (Fig. 7• To complete the securing procedure in a vehicle, use the Steady Fix device. Open the clip and pass the diagonal strap through it, ensuring that it is taut and not twisted (Fig. 8• IMPORTANT: Take hold of the safety belt and pull it upwards firmly to fit Viaggio1 Duo-Fix more closely to the seat of the vehicle (Fig. Once the procedure is complete, it is possible to recline the seat to the desired position (See Point 2). Attachment in vehicles with safety belts Instructions for use SEMI-UNIVERSAL CATEGORY Attachment in vehicles with an Isofix Base 0+1 Instructions for use UNIVERSAL CATEGORY Before attaching Viaggio1 Duo-Fix to the Isofix Base, fit the Base on the seat of the vehicle by following the instructions provided with the base. 9• If the base is already attached in the vehicle, ensure that its Isofix attachments are extended to their maximum length. 1 0• Remove the protective base attached to the car seat with the special release switches (Arrows A and B). 1 1• Position the car seat on the Isofix Base 0+1 and secure the rear connectors of the car seat to the attachment points 24 of the base nearest to the vehicle seat (Arrow A). Press the front part of the car seat until it clicks into place (Arrow B). 1 2• IMPORTANT: The two signals behind the Isofix Base go from red to green to indicate that the car seat is properly attached to the base. 1 3• Pull the handle on the base (Arrow A) and push the base with the car seat against the vehicle’s seat until they can go no further (Arrow B). IMPORTANT: It is possible to check that the Isofix base is correctly positioned by looking at the signals on the handle. OK (green) indicates that the position is correct, NO (red) indicates that the procedure has been carried out incorrectly and must be repeated until the handle only shows the term “OK”. IMPORTANT: Once the procedure is complete, move the base to check that both Isofix points are actually attached. IMPORTANT: Grab hold of the safety harness under the shoulder pads, as shown in the picture. € The seat has a booster cushion which is suitable for small babies and when the safety harnesses are in the first level. When the child is older, remove the booster cushion. 2 1• To remove the booster cushion, pull it out of the safety harness and the sides of the car seat. The head rest must be adjusted to match the child’s height. [. . . ] € The top of the label displays the trademark of the manufacturing company and the name of the product. € The letter E in a circle indicates the European approval mark and the number indicates the country that issued the approval (1: Germany, 2: France, 3: Italy, 4: Netherlands, 11: Great Britain, 24: Republic of Ireland). € Approval number: if it starts with 04, this indicates the fourth amendment (the one currently in force) of Regulation R44. • Reference standard: UN/ECE R44/04. [. . . ]