User manual PEG-PEREGO BOOK

[. . . ] E N• Spare parts available in different colours to be specified when ordering. WARNING IMPORTANT: read these instructions carefully and keep them for future use. The child’s safety could be at risk if these instructions are not followed. _ This product was designed for the transport of 1 child in the seat. [. . . ] 9• Button the hood onto the stroller's backrest (Fig. To remove the hood: unfasten the hood's side attachments from the chassis by pressing the external button (as shown in Fig. E) and unbutton it from the backrest, the sides of the stroller and inside the handle. - a window with UV protection, to see the child (Fig. 11• The hood can be adjusted to two positions (Fig. B) and stretch the fabric flap to see the child and to let more air under the hood (Fig. 1 2• MUFF for complete Book: to put the muff on the stroller, button it up under the footrest and slide it upwards over the bumper, then button it again (Fig. The muff has an extra little muff for the child's hands (Fig. 1 3• RAINCOVER for complete Book: to fit the rain canopy, extend it over the stroller and snap fit the buttons on both sides of the hood (Fig. Fasten the elastic loops including the chassis in the lower part of the stroller (Fig. € Do not use the rain canopy indoors and always make sure that the child is not too hot. € Do not place the rain canopy near heat sources and pay attention to cigarettes. € Make sure that the rain canopy does not interfere with any moving mechanism of the stroller. € Always remove the rain canopy before folding up the stroller. 1 4• 5-POINT SAFETY HARNESS: to fasten, insert the two buckles of the waist strap (with attached shoulder straps, arrow a) into the leg divider strap until they click into place (arrow b). To unfasten them, press the button which is situated in the centre of the fastener (arrow c) and pull the waist strap outwards (arrow d). 1 5• To tighten the waist strap, pull on both sides in the direction of the arrow. 1 6• To adjust the height of the safety harnesses, release the two buckles on the rear of the backrest. Pull the shoulder straps towards you (arrow a) until the buckles are released and insert them in the backrest loops (arrow b). Remove the shoulder straps from the sack (arrow c) and insert them in the most appropriate buckle (arrow d), then reattach the two buckles behind the backrest (arrow e). The buckles are securely attached when a click is heard (fig f). WARNING: To fasten the belts in the third eyelet, lift the fabric, as they are hidden in the lining. [. . . ] Replace the main handle's screw (fig_b). wARNING: stretch the strap to check it is securely fastened. - Button the lining onto the stroller's backrest (27h). 31• Insert the lining's elastic into the groove and stretch it from inside to fasten it (fig_c). [. . . ]