User manual PENTAX EI200

[. . . ] These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does not cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. [. . . ] Press the OK button again to make the change. The cursor returns to the CAPTURE MENU. This setting is reset to 0. 0 when the camera power is off. The setting is conserved even if the camera power is off. The flash effective range is 0. 4m - 2m (1. 3feet - 6feet). How to adjust the White Balance? To adjust the White Balance, perform the following: 1. Select the WHITE BALANCE item by the arrow buttons ( / ) and then press the OK button to confirm. Use the arrow buttons ( / ) to select the desired white balance setting. Press the OK button again to make the change. The cursor returns to the CAPTURE MENU. This setting is reset to AUTO when the camera power is off. How to set the Self-Timer? To use the Self-Timer function, perform the following: 1. Set the Operating Mode Dial to CAPTURE . Press the Self-Timer button to set the Self-Timer on. After 10 seconds, an image is captured and the timer will turn itself off. The Self-Timer is located in front of the camera, and it is designed to count down for 10 seconds. In the first 7 seconds, the indicator lights up and then blinks rapidly for the last 3 seconds. How to set the OSD (On-Screen Display) language? To s e t t h e O S D l a n g u a g e , p e r f o r m t h e following: 1. Select the LANGUAGE item by the arrow buttons ( / ) and then press the OK button to confirm. Use the arrow buttons ( / ) to select the desired white balance type. Press the OK button again to make the change. The cursor returns to the CAPTURE menu automatically when the change is made. This setting is reset to AUTO when the camera power is off. increase/decrease the EV compensate value (-2. 0 ~ +2. 0). Press the OK button again to make the change. The cursor returns to the CAPTURE menu automatically when the change is made. This setting is reset to O. O when the camera power is off. DIGITAL ZOOM: Press the DISPLAY button. In CAPTURE mode, you can see the close-up effect on the LCD Monitor by pressing the OK button to activate 2X digital zoom function. Digital Zoom is only available in the 1280x960 recording pixels. Reference: The approximate color temperature of the 4 above white balance settings (except Auto White Balance) will be Daylight = 5500K, Shade= 6000K, Tungsten = 2850K and Fluorescent = 4000K. EV COMPENSATION: Adjusts the exposure compensation over a range of -2. 0 to +2. 0 EV in steps of 0. 3 EV, where 1. 0 EV = 1 f-stop. Select the item by the arrow buttons ( / ) and then press the OK button to confirm. The cursor skips to the last field as the OK button being pressed. Use the arrow buttons ( / ) to 16 PLAY Mode In Play mode, users can review the captured images on the LCD Monitor or on a TV. Set the Operating Mode Dial to PLAY for image review. Play Menu Press the Menu button in PLAY mode, the Play menu appears. [. . . ] Battery icon with 1 bar on: Prepare new batteries. Battery icon with no bars on: There is no battery power remaining, the batteries need to be replaced. The camera will be forced to power it off at once. Self-Timer Button The Self-Timer button is active only in CAPTURE mode. When the Self-Timer button is pressed, the 10-second self-timer is enabled. [. . . ]