User manual PENTAX ESPIO 80V

[. . . ] 23) y Self-timer/AF infinity-landscape button (p. 22) i Built-in flash o Viewfinder window !0 Zoom lens !1 Autofocus window !2 Self-timer lamp (P. 25) !3 Light sensor window !4 Back cover release lever (p. 19) !6 Zoom lever !7 Film information window !8 Battery chamber cover !9 Tripod socket (p. [. . . ] After the data has been adjusted, depress the SELECT button w. The bar mark ( - ) appears on the LCD panel, indicating that data imprinting choices are possible. Operational precautions · As you release the shutter, the bar ( - ) mark on the display blinks for a few seconds, indicating the data has been imprinted. · If there is a white or yellow object in the corner of the picture where the data is imprinted, the data may be difficult to read. When composing your photographs, try to avoid brightly-colored subjects in that corner. MAIN SWITCH AND BATTERY CHECK MAIN SWITCH Push the main switch button to switch ON. The lens extends slightly and the LCD panel is now on. To switch OFF, push the main switch button again. · If the camera is ON and left unused for over 3 minutes, the lens automatically retracts and the power is turned off to save the battery. · Use one 3V lithium battery, type CR123A or the equivalent. Do not remove the battery before it is exhausted. If the battery is removed, the data on the DATE MODEL is initialized. BATTERY CHECK After you turn the main switch ON, the lens slightly extends and the lens cover opens. Shooting Depress the shutter release button fully. The film automatically advances to the next frame. · If the autofocus window is dirty, the autofocus may not function properly. · If you wish to focus on another subject, lift your finger from the shutter release button and depress the shutter button halfway down again. · While the lamp is blinking, shutter cannot be released. · Ensure that the lamp is lit continuously, before taking pictures. 20 Automatic Flash Emission When the shutter release button is depressed halfway down in low light, the flash is automatically charged and the green lamp lights up and ( ) will appear to ( ) on the LCD panel indicating the flash is ready to discharge. · The automatic flash emission is set automatically when the main switch is ON. Flash effective ranges (Color negative film used) ISO Lens 38mm ( 115mm ( ) ) 100 0. 8-3. 9m (2. 6-13ft) 0. 8-1. 4m (2. 6-4. 6ft) 400 0. 8-7. 9m (2. 6-26ft) 0. 8-2. 8m (2. 6-9. 2ft) 1. 9-1) After you have exposed the last frame of the roll, the lens retracts and the film rewinds automatically. Then, the motor stops, and ( ) blinks for approx. 5 seconds to indicate that the film has been rewound completely. And the power will turn OFF automatically. [. . . ] · If you are standing directly in front of the camera when starting the Self-Timer, the camera will be focused to you, not the main subjects. Be sure that you are behind, or next to the camera when starting the SelfTimer. · If you wish to use the flash with the self-timer, ensure that the arrow mark on the LCD panel appears and points to ( ) indicating the flash has been charged before operating the self-timer. 25 English 4. TAKING PICTURES AT A SLOW SHUTTER SPEED SELF-TIMER PHOTOGRAPHY INFINITY-LANDSCAPE SHOOTING When you wish to take a sharp picture of a distant landscape or a distant subject through a window, the Infinitylandscape mode allows you to capture distant scenery with clarity. [. . . ]