User manual PENTAX ESPIO MINI

[. . . ] Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not approved by the party responsible for compliance could void the user`s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. 9 Zoom button @0 Film information window @1 Battery chamber cover @2 Back cover @3 Panorama switch @4 Tripod socket @5 Mid-roll rewind button @6 Back cover release lever * Protrusion A can be used for pushing the mid-roll rewind button. 1 Insert the battery with the plus (+) side up in accordance with the indication label in the battery chamber. Pull out the film leader end to reach the [FILM ] mark q. If there is dirt on the film detector w, the film cannot be wound properly. If "E" blinks on the LCD panel, repeat step 24 to load the film properly. Compose your subject by using the zoom button and focus on the subject within the autofocus frame. 7 Press the shutter release button halfway down to confirm the focus with green icon lamp lights on, and press the shutter button completely to take a picture. This can be used when a portrait is taken with a back light situation or as a fill-in flash in daylight. Slow shutter speed with Flash-OFF ( ) The flash will not discharge. Use this mode in place where flash picture is prohibited or for a natural existing light effect in low ambient photography. Slow shutter speed with Red-eye reduction flash ( ) It is possible to take subjects and background in a balance way by using the flash to properly expose the foreground subject and slow speed to expose the low light background. Bulb mode with Flash OFF ( ) This mode is useful for longer exposures required for shooting firework and night scenes. Mode with Flash ON ( ) This let you use the flash in addition to the Bulb mode, you can take a portrait picture with a night scene in the background. Red-eye reduction Flash To reduce the red-eye phenomenon in the picture, the flash discharges once to make subject's pupil smaller. And then, take a picture in the flash mode after brief interval. Focus on the subject and press the shutter release button fully to start the self-timer. The picture will be taken10 seconds after the shutter release button is pressed. [. . . ] Focus on the subject and press the shutter release button fully to start the self-timer. The picture will be taken10 seconds after the shutter release button is pressed. the selftimer is engaged and the self-timer lamp lights. 3 seconds after the self-timer lamp starts to blinks. [. . . ]