User manual PENTAX SMC REFLEX 2000MM F13.5

[. . . ] Images taken with the purpose of obtaining copyrights also cannot be used outside the scope of use of the copyright as laid out in the Copyright Act, and care should be taken here also. Regarding trademarks · The SD logo is a trademark. · PENTAX is a trademark of PENTAX Corporation. · Optio is a trademark of PENTAX Corporation. [. . . ] For taking pictures outside in sunlight. For taking pictures outside in the shade. For taking pictures under bulb or other incandescent Tungsten Light lights. Fluorescent For taking pictures under fluorescent light. Light For taking pictures by manually adjusting the white Manual balance. 4 Taking Pictures 1 2 3 4 Select [White Balance] on the [A Rec. Press the four-way controller (5). The White Balance selection screen will be displayed. White Balance AWB Use the four-way controller (23) to select the setting. Press the OK button twice. The camera is ready to take the picture. Saving the White Balance 1 p. 68 MENU Exit OK OK You can change the setting in Picture mode but these changes are not reflected when shooting. 45 Setting Manually 1 2 3 4 4 Taking Pictures 46 Select [K] (Manual) on the White Balance selection screen. Point your camera at a blank sheet of paper so that it fills the screen. Press the OK button. White Balance AWB MENU Exit OK OK The white balance is automatically adjusted, [Complete] appears on the LCD monitor and the display returns to the menu screen. Press the OK button. The camera is ready to take the picture. Rec. Mode Recorded Pixels Quality Level White Balance Focusing Area AE Metering Sensitivity MENU 2048 1536 AWB Wide Auto OK 2 3 1 Exit OK A BFD 4 Taking Pictures Setting the Focusing Area You can change the autofocus area. Wide Spot Normal range The autofocus range becomes smaller. 1 2 3 Select [Focusing Area] on the [A Rec. Use the four-way controller (45) to change the setting. Press the OK button. The camera is ready to take the picture. Rec. Mode Digital Zoom Instant Review Memory Sharpness Saturation Contrast MENU 0. 5sec Exit OK OK Rec. Mode Recorded Pixels Quality Level White Balance Focusing Area AE Metering Sensitivity MENU 2048 1536 AWB Wide Auto OK 2 3 1 Exit OK ABFD Setting the Color Saturation You can set the color saturation. 4 Taking Pictures 1 2 3 Select [Saturation] on the [A Rec. Use the four-way controller (45) to select x (Normal), z (High), or y (Low). Press the OK button. The camera is ready to take the picture. Rec. Mode Digital Zoom Instant Review Memory Sharpness Saturation Contrast MENU 0. 5sec Exit OK OK ABFD Setting the Image Contrast You can set the image contrast. 1 2 3 Select [Contrast] on the [A Rec. Use the four-way controller (45) to select x (Normal), z (High), or y (Low). Press the OK button. The camera is ready to take the picture. Rec. Mode Digital Zoom Instant Review Memory Sharpness Saturation Contrast MENU 0. 5sec Exit OK OK 51 Rec. Mode Recorded Pixels Quality Level White Balance Focusing Area AE Metering Sensitivity MENU 2048 1536 AWB Wide Auto OK 2 3 1 Exit OK A BCFD EV Compensation 4 Taking Pictures 52 You can take pictures that are intentionally over-exposed or underexposed. 1 2 Select [EV Compensation] on the [A Rec. [. . . ] · The local warranty policies available from PENTAX distributors in some countries can supersede this warranty policy. Therefore, we recommend that you review the warranty card supplied with your product at the time of purchase, or contact the PENTAX distributor in your country for more information and to receive a copy of the warranty policy. 7 Appendix The CE Mark is a Directive conformity mark of the European Community. 103 7 Appendix 104 For customers in USA STATEMENT OF FCC COMPLIANCE This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications not approved by the party responsible for compliance could void the user's authority to operate the equipment. [. . . ]