User manual PFAFF SMART 300E

[. . . ] USER'S GUIDE 300 e This houshold sewing machine is designed to comply with IEC/EN 60335-2-28 and UL1594 IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic safety precautions should always be followed, including the following: Read all instructions before using this household Sewing machine. DANGER ­ To reduce the risk of electric shock: · · A sewing machine should never be left unattended when plugged in. Always unplug this sewing machine from the electric outlet immediately after using and before cleaning. Replace bulb with same type rated 5 Watt. WARNING ­ To reduce the risk of burns, fire, electric shock, or injury to person: · · · Do not allow to be used as a toy. Close attention is necessary when this sewing machine is used by or near children or infirm persons. [. . . ] Position - This light is displayed after design selection. You may position the hoop to a starting point other than center. The Directional buttons move the hoop in the direction indicated by the arrow. Sewing - This LED light is lit when the machine is stitching a design. If you temporarily have stopped your design by touching the Start/Stop button it will also be lit. 23 User's Guide Thread - Indicates that the machine is stopped for a thread break. Color - Indicates the machine is stopped for a thread color change. USB - The LED light is lit when you are reading/writing designs to/from your computer to the machine. Error- Indicates a condition that needs attention. See Help code list on pages 34-35 for explanation and action to be taken. Directional buttons The Directional buttons are used in conjunction with function buttons to navigate through designs and functions, as well as to move the hoop. During bobbin winding, the "up" button will cause the winder to speed up, the "down" button will cause the winder to slow down. 24 CONNECTIVITY TO YOUR COMPUTER User's Guide Connectivity to your computer When opening the 3D Embroidery Intro for the first time or after rebooting, you will get a message stating that you should turn on the machine. Click on the OK button and the 3D Embroidery Intro and the Navigator will be turned on. To be able to load the embroideries to your machine you need to install the software on your PC computer and connect the machine to your computer with the cable. In the 3D Embroidery Intro software you will be able to adjust your embroideries before you stitch them out. How to transfer designs to the machine 1. Ensure the embroidery machine is connected to your computer and turned on. Click the Start button at the bottom left of your computer screen and the Start menu appears. Move the arrow pointer to All Programs and another menu will appear. Move the arrow pointer to 3D Embroidery Intro and a menu of modules will appear. Click on 3D Embroidery Intro to launch it. 3D Embroidery Intro and 3D Navigator will start. The Navigator icon will appear in the system tray. Open a design by clicking on the View Designs icon . In the Viewer dialog box click on the browse folder icon with three dots. Browse to the folder C:\3DEmbroideryIntro\Samples\3DEmb1\ and choose the folder you want to open. Click on the design you want to open. 26 CONNECTIVITY TO YOUR COMPUTER Send Click on Send to transfer the embroidery on the screen to the embroidery machine, ready to be stitched out. [. . . ] Check that the machine is threaded, the hoop is attached, and the presser foot is lowered. Press the Start/Stop key on the machine. The machine will stop at the end of the first color. Raise the presser foot and change the thread color. [. . . ]