User manual PHILIPS AVENT SCF255/57

[. . . ] This is not a heating guide for liquid or food!Setting 1 2 3 Approximate water* temperature surrounding the container 35 – 45 °C 45 – 75 °C 75 – 85 °C GB EITHER: Mix one sachet of citric acid (10g) with 200ml/7oz of water. After 10 minutes, switch off by unplugging from the wall and leave to stand for 30 minutes. Pour the solution away and rinse the warmer with tap water. [. . . ] Do not leave in sunlight when not in use or for longer than recommended in heat or sterilising solution, as this may weaken the product. Always use this product with adult supervision. Always check food temperature before feeding. Contents a) b) c) d) Basket Warmer body Dial Baby food container and weaning spoon Instructions for Use For Airflex Feeding Bottles 1) Ensure basket is in place inside the warmer. 2) Place the assembled, filled bottle in the warmer. 3) For 125ml/4oz Airflex Bottles, fill the warmer with water to just above the level of milk in the bottle. 4) For larger Airflex Bottles (260ml/9oz), fill the warmer to 15mm (1/2 inch) below the rim of the warmer. 5) Never let the water level rise above the neck of the bottle or spill over the edge of the warmer. 6) Plug in the unit and switch on at the mains. 7) The light will illuminate to indicate the warmer is working. 4 For baby food jars and tins 1) Ensure basket is in place inside the warmer. 2) Remove the lid and place jar or tin in the warmer. 3) Fill the warmer with water to 15 mm (1/2 inch) below the top of the jar/tin. 4) Plug in the unit and switch on at the mains. 6) The warmer will work in the same way as for feeding bottles. Take care when removing the jar or tin as they, and the water surrounding them, will be hot. 7) For small jars/tins you may find it beneficial to place a screw ring from an AVENT Airflex Bottle below the jar/tin before adding the water in order to remove the container easily. 8) Stir the food and test it on a spoon yourself to ensure it is not too hot for your baby. The Express Bottle and Baby Food Warmer is fitted with a non-rewireable moulded plug. The mains supply cord of the appliance CANNOT be replaced. If the cord is damaged, the appliance should be discarded. The lead supplied must not be used on any other appliance and no other lead should be used with the Express Bottle and Baby Food Warmer. [. . . ] This does not affect your statutory rights. Care of your warmer Unplug and allow to cool before cleaning. Remove basket and wipe inside and outside with a damp cloth only, this will keep the warmer looking new. It may be advantageous to use pre-boiled or filtered water in your warmer in order to reduce limescale build up. [. . . ]