User manual PHILIPS 160E1SB

[. . . ] Philips LCD Monitor Electronic User's Manual · Safety Precautions and Maintenance · FAQs · Troubleshooting · Regulatory Information · Other Related Information Safety and Troubleshooting Information Safety precautions and maintenance WARNING: Use of controls, adjustments or procedures other than those specified in this documentation may result in exposure to shock, electrical hazards and/or mechanical hazards. Read and follow these instructions when connecting and using your computer monitor: Operation: %Ï %Ï %Ï %Ï %Ï %Ï %Ï %Ï Keep the monitor out of direct sunlight and away from stoves or any other heat source. Remove any object that could fall into ventilation holes or prevent proper cooling of the monitor's electronics. Do not block the ventilation holes on the cabinet. When positioning the monitor, make sure the power plug and outlet are easily accessible. [. . . ] 5Select the 'Monitor' button, point to 'Change. . . ' then click on 'Next' . 6Select 'Display a list of all the drivers in a specific location, so you can choose the driver . you want. ' then click on 'Next' and then click on 'Have Disk. . . '. 7Click on the 'Browse. . . ' button, select the appropriate drive F: ( CD-ROM Drive) then click . on the 'OK' button. 8Click on the 'OK' button then select your monitor model and click on the 'Next' button. 9Click on the 'Finish' button then the 'Close' button. . For Windows® 2000 1Start Windows® 2000 . Click on the 'Start' button, point to 'Settings', and then click on 'Control Panel'. 3Double click on the 'Display' Icon. 4Select the 'Settings' tab then click on 'Advanced. . . '. 5Select 'Monitor' . - If the 'Properties' button is inactive, it means your monitor is properly configured. - If the 'Properties' button is active. 6Click on 'Driver' and then click on 'Update Driver. . . ' then click on the 'Next' button. 7Select 'Display a list of the known drivers for this device so that I can choose a specific . driver', then click on 'Next' and then click on 'Have disk. . . '. 8Click on the 'Browse. . . ' button then select the appropriate drive F: ( CD-ROM Drive). 9Click on the 'Open' button, then click on the 'OK' button. 1 Select your monitor model and click on the 'Next' button. 1 Click on the 'Finish' button then the 'Close' button. If you can see the 'Digital Signature Not Found' window, click on the 'Yes' button. For Windows® Me 1Start Windows® Me . 2Click on the 'Start' button, point to 'Settings', and then click on 'Control Panel'. 3Double click on the 'Display' Icon. 4Select the 'Settings' tab then click on 'Advanced. . . '. 5Select the 'Monitor' button, then click on 'Change. . . ' button. 6Select 'Specify the location of the driver(Advanced)' and click on the 'Next' button. 7Select 'Display a list of all the drivers in a specific location, so you can choose the driver . you want', then click on 'Next' and then click on 'Have Disk. . . '. 8Click on the 'Browse. . . ' button, select the appropriate drive F: ( CD-ROM Drive) then click . on the 'OK' button. 9Click on the 'OK' button, select your monitor model and click on the 'Next' button. [. . . ] The controller provides the interface registers to allow communication to/from the host. Hub specific status and control commands permit the host to configure a hub and to monitor and control its ports. Device A logical or physical entity that performs a function. The actual entity described depends on the context of the reference. [. . . ]