User manual PHILIPS 190EL1SB

[. . . ] Philips LCD Monitor Electronic User's Manual · Safety Precautions and Maintenance · FAQs · Troubleshooting · Regulatory Information Safety and Troubleshooting Information Safety precautions and maintenance WARNING: Use of controls, adjustments or procedures other than those specified in this documentation may result in exposure to shock, electrical hazards and/or mechanical hazards. Read and follow these instructions when connecting and using your computer monitor: Operation: %Ï %Ï %Ï %Ï %Ï %Ï %Ï %Ï Keep the monitor out of direct sunlight and away from stoves or any other heat source. Remove any object that could fall into ventilation holes or prevent proper cooling of the monitor's electronics. Do not block the ventilation holes on the cabinet. When positioning the monitor, make sure the power plug and outlet are easily accessible. [. . . ] Enable Theft and PIN Options . buttons. 3Entering incorrect PIN results in the following dialog box: . Options>Preferences - Will only be active when selecting Preferences from the drop-down Options menu. On a nonsupported display capable of DDC/CI, only the Help and Options tabs are available. 1Displays current preference settings. 3Enable Context Menu on desktop is checked (On) by default. Enable Context menu displays SmartControl II selections for . Select Preset and Tune Display in the desktop right-click context menu. Disabled removes SmartControl II from the right click context menu. 4Enable Task Tray icon is checked (On) by default. Enable context menu shows the task tray menu for SmartControl II. click on the task tray icon displays the menu options for Help, Technical Support. When Enable task tray menu is disabled, the task tray icon will only display EXIT. 5Run at Startup is checked (On) by default. When disabled, SmartControl II will not launch at start or be in the task tray. only way to launch SmartControll II is either from the desktop short cut or from the program file. Any preset set to run at startup will not load when this box is unchecked (Disabled). 6Enable transparency mode (Vista, XP, and 2k only). Options>Input - Will only be active when selecting Input from the drop-down Options menu. On a non-supported display capable of DDC/CI, only the Help and Options tabs are available. All other SmartControl II tabs are not available. Display the Source instruction pane and current input source setting. 2On single input displays, this pane will not be visible. . Options>Auto - Will only be active when selecting Volume from the drop-down Options menu. On a non-supported display capable of DDC/CI, only the Help and Options tabs are available. Option>Auto Pivot Help>User Manual - Will only be active when selecting User Manual from the drop-down Help menu. On a non-supported display capable of DDC/CI, only the Help and Options tabs are available. Help>Version - Will only be active when selecting Version from the drop- down Help menu. On a non-supported display capable of DDC/CI, only the Help and Options tabs are available. Context Sensitive menu The Context Sensitive menu is Enabled by default. If Enable Context Menu has been checked in the Options>Preferences pane, then the menu will be visible. The Context Menu has four entries: 1SmartControll II - When selected the About Screen is displayed. [. . . ] For more information, contact the Philips Customer Care Center by calling (877) 835-1838 (U. S. A. Please check your owner's manual before requesting service. Adjustments of the controls discussed there may save you a service call. TO GET WARRANTY SERVICE IN U. S. A. , PUERTO RICO OR U. S. Contact the Philips Customer Care Center phone number listed below for product assistance and procedures for servicing: Philips Customer Care Center (877) 835-1838 or (919) 573-7855 (In U. S. A. , Puerto Rico and U. S. [. . . ]