User manual PHILIPS 32FD9944/01S

[. . . ] & Connect one end of a VGA cable to the video card of the computer and the other end to the VGA IN connector at the rear side of the receiver box. Fix the connectors firmly with the screws on the plug. In case of a Multimedia computer, connect the audio cable to the audio outputs of your Multimedia computer and to the AUDIO VGA R (right) and L (left) inputs of the receiver box. Serial I/O port RS232 The RS232 connector is only to be used with the monitor as stand alone. This connector allows you to control the monitor via your PC (as a replacement of the remote control). [. . . ] Please ensure you dispose of batteries according to local regulations. End of life directives Philips is paying a lot of attention to produce environmentally-friendly in green focal areas. Your new monitor contains materials which can be recycled and reused. At the end of its life specialised companies can dismantle the discarded monitor to concentrate the reusable materials and to minimise the amount of materials to be disposed of. Please ensure you dispose of your old monitor according to local regulations. 3 Use of the menus and the menu system Picture 1 Picture 2 Contrast Colour temp. Sharpness Sound Setup Brightness Contrast This control allows you to adjust the contrast level of the picture. Colour temperature This control allows you to select the colour temperature of the picture. Move the cursor up/down to make a selection. Press the cursor left to return to the Picture 1 menu. Sharpness This control allows you to adjust the edge definition of a picture. & Press the MENU key on the remote control to summon the different menu headers. é Press the cursor left/right to move the cursor horizontally through the menu headers. " Press the cursor down to access the menu. In case of a slider, move the cursor left/right to adjust. In case of a list with options, move the cursor right to enter and use the cursor up/down to select an option. Press the cursor left to leave the options list. ` Press the MENU key again to switch off the Picture 2 menu Picture 2 Format Zoom Zoom factor Shift Clock frequency Phase Auto align 4:3 Wide screen menu. Note: Sometimes not all the menu items are visible on the screen. Press the cursor down until all the items are displayed. Only when the US English language has been selected (see Setup menu, Language, p. 5), the menu items will be displayed with additional icons. 4:3 Wide screen Operation Press the MENU key on the remote control to summon the main menu. In this menu you are allowed to adjust attributes which are relevant for the picture on the display, like format, zoom, size, etc. Format Select Format to summon a list of available display formats for showing images in the traditional 4:3 proportions. Press the cursor up/down to select another display format: 4:3 or Wide screen. Zoom Select Zoom On to activate the zoom function. You may also activate the zoom function with the ZOOM ON/OFF key on the remote control. Press the cursor left/right, up/down to select which part of the screen will be zoomed. Picture 1 menu Picture 1 Brightness Contrast Colour temperature Sharpness Brightness This control allows you to adjust the brightness level of the picture. 4 Zoom factor Select Zoom factor and press the cursor left/right to adjust the zoom factor and to change the magnification of the picture. If zoom is not active, Zoom Off, changing the magnification factor will have no effect on the displayed picture. Shift This control allows you, when necessary, to move the picture in a horizontal or vertical way. & Use the cursor left/right to adjust. [. . . ] 1 year) the screen may display some strange colour deficiencies. This is quite normal for plasma displays and these effects will 6 disappear after the set has been turned on for some time. A plasma display consists of a huge amount of colour pixels. It is within industry standards that very few pixels (< 0. 001%) may be defective, even for a new set. [. . . ]