User manual PHILIPS 40341-31-16

[. . . ] Retain this information for future reference. ________________________ CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This "bolt of lightning" indicates uninsulated material within your unit may cause an electrical shock. For the safety of everyone in your household, please do not remove product covering. [. . . ] SETTING TIMES !ALARM 1, ALARM 2, TIME - sets the respective alarm or clock time @7 , 8 - adjusts clock/ alarm times; - adjusts the gentle wake minimum and maximum volume level for alarm 1 or 2; - selects a CD wake up track for alarm 1 or 2. $Dial lens CONTROLS/ INSTALLATION %SET DAY - sets the day for weekend sleeper activation. ^24 HR RESET - stops the active buzzer, radio or CD alarms for 24 hours. &LIFT TO OPEN - opens/ closes CD door. (Pigtail - antenna to improve FM reception. The type plate is located on the bottom of the set. This product complies with the FCC-Rules, Part 15 and with 21 CFR 1040. 10. Operation is subject to the following two conditions: 1 This device may not cause harmful interference, and 2 This device must accept any interference received, including interference that may cause undesired operation. CAUTION Use of controls or adjustments or performance of procedures other than herein may result in hazardous radiation exposure or other unsafe operation. INSTALLATION Power Supply and Demo mode 1 Check if the power voltage, shown on the type plate on the bottom of the set, corresponds to your local power supply. If it does not, consult your dealer or service center. 2 While the day display is shown, press SET DAY again once or more to select the day numbered from dAY 1-7 (Monday-Sunday): TM The display will revert to show the clock time. 1 To open the CD door, lift at the edge marked LIFT TO OPEN. 2 Insert a CD with the printed side facing up, and close the door. 3 Press PLAY/ PAUSE 2; to start playback. TM The CD indicator CD , Cd:-- and the total number of tracks are shown, followed by the first track number before returning to clock time. ­ door is shown if you have not closed the CD door/ open the CD door during playback. ­ noCd is shown if no CD has been inserted/ inserted incorrectly. ­ nFCd is shown if the CD-R(W) is non-finalized ­ Err indicates a general error in operation of the set. · The current track number shows briefly before returning to clock time. 6 Press PLAY/ PAUSE 2; again to resume playback. Adjusting the Gentle Wake Volume A sure way of getting up in the mornings, the gentle wake volume for the alarm begins from gentle volume e. g Lo:00 (low) and gradually increases to a higher volume e. g. The default volume range is Lo:00 and H1:16. [. . . ] There are four sleep times before the set turns itself off: 10, 30, 60, 90 minutes and off. The sleep function does not affect the operation of your alarm settings. Setting Sleep 1 Press PLAY/ PAUSE 2; (CD) or ON/ OFF (radio) to switch on the respective mode. · For the CD mode, make sure you have inserted a disc first. [. . . ]