User manual PHILIPS 407411116

[. . . ] e Do not use this apparatus near water. g Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. h Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 2 EN m Unplug this apparatus during lightning storms or when unused for long periods of time. [. . . ] Do not mix different brands of batteries. Remove batteries from products that are not in use for a longer period of time. •• Risk of injury: Wear gloves when handling leaking batteries. Keep batteries out of reach of children and pets. •• Risk of explosion: Do not short circuit batteries. Do not expose batteries to excessive heat. Do not recharge non-rechargeable batteries. English Notice the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • • • Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. b Battery compartment c OFF/ON • Switch the microphone on or off. d Power indicator • Light up red when the wireless microphone is switched on. • Flash red when the battery level is low. EN 5 English What’s in the box Bluetooth® speaker a c b d ef i hg a Power indicator • Indicate the power status. c Bluetooth® indicator • Indicate the Bluetooth® status. e • (Press) pair with a Bluetooth® enabled device that supports A2DP (Advanced Audio Distribution Profile). • (Press and hold) pair with the wireless microphone in case automatic pairing fails. f Dock for iPad g SOFTWARE UPGRADE (not for use by end users) h AUDIO-IN • Connect an external audio player through a 3. 5mm audio input cable (not supplied). i AC MAINS~ • AC power socket. 6 EN • Always follow the instructions in this chapter in sequence. To switch the unit on from standby mode, press again. Tip Connect power Caution •• Risk of product damage!Make sure that the power supply voltage corresponds to the voltage printed on the back of the unit. When you unplug the AC power cord, always pull the plug from the socket. •• Before you connect the AC power cord, make sure that you have completed all the other connections. •• If the speaker stays idle for more than 15 minutes, it switches to standby mode automatically. Install/replace microphone batteries Caution •• Risk of explosion! [. . . ] If the problem remains unsolved, go to the Philips Web page (www. When you contact Philips, make sure that the device is nearby and the model number and serial number are available. No power to the Bluetooth® speaker •• Make sure that the AC power plug of the device is connected properly. •• Make sure that there is power at the AC outlet. [. . . ]