User manual PHILIPS 40760-38-16

[. . . ] Danger - Make sure the adapter does not get wet. Always check if the water is not too hot, to prevent your hands from getting burnt. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. - The shaver, the Power Pod and the charger are not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliances by a person responsible for their safety. [. . . ] In this case, the motor cannot run because the shaving heads are soiled or damaged. note:The displays of types RQ1062 , RQ1060 , 40760-38-16 and RQ1050 look different but show the same indication. - When this happens, you have to clean the shaving unit or replace it. - The shaving unit symbol and the tap symbol with exclamation mark continue to flash until you unblock the shaving heads. A fully charged shaver has a shaving time of up to 65 minutes, which is enough for approx. If you have a heavy beard, the shaving time may be less than 65 minutes. The shaving time may also vary over time, depending on your shaving behaviour and beard type. Quick charge After the shaver has charged for 5 minutes, it contains enough energy for one shave. 4 First insert the top of the shaver into the Power Pod (1) and then press the bottom part into the Power Pod (2). Note:The shaver cannot be placed in the Power Pod when the protection cap is on the shaving unit. Press the shaver tightly into the holder to lock into place. 4 Carefully shake off excess water and leave the shaving heads open to let the shaving unit dry completely. Never dry the shaving unit with a towel or tissue, as this may damage the shaving heads. , For thorough cleaning, switch on the shaver and immerse the shaving unit in hot water with some liquid soap for 30 seconds. You can also clean the shaving unit with some alcohol. Cleaning the shaving unit with the brush supplied 1 Switch off the shaver. 2 Pull open the three shaving heads one by one. 3 Clean the shaving heads and the hair chambers with the brush supplied. Cleaning the trimmer with the brush supplied Clean the trimmer every time you have used it. 4 Switch the shaver on and off and repeat step 3. 5 Press the trimmer slide backwards to retract the trimmer. Tip: For optimal trimmer performance, lubricate the trimmer teeth with a drop of sewing machine oil every six months. [. . . ] If you have trouble removing the battery, you can also take the appliance to a Philips service centre. The staff of this centre will Remove the battery for you and will dispose of it in an environmentally safe way. disposal of the shaver battery Only remove the battery when you discard the shaver. Make sure the battery is completely empty when you remove it. [. . . ]