User manual PHILIPS 4CM6282

[. . . ] Interference The Department of Trade and Industry operates a Radio Interference Investigation Service to help TV license holders improve reception of BBS and IBA programmes where they are being spoilt by interference. If your dealer cannot help, ask at a main Post Office for the booklet "How to Improve Television and Radio Reception". mains Connection Before connecting the TV to the mains , check that the mains supply voltage corresponds to the voltage printed on the type plate on the rear panel of the TV. If the mains voltage is different, consult your dealer. [. . . ] Make sure that air can circulate freely through the ventilation slots To prevent any unsafe situations, no naked flame sources, such as lighted candles, should be placed on or in the vicinity. Avoid heat, direct sunlight and exposure to rain or water. The equipment shall not be exposed to dripping or splashing and no objects filled with liquids, such as vases, shall be placed on it. Insert the aerial plug firmly into the aerial socket at the bottom of the TV. Insert the mains plug into the wall socket and switch on. Please refer to the label on the back of the television for the correct operating voltage. Remove the cover at the back of the remote control. Insert the correct type and size batteries into the compartment making sure they are the right way around. You can secure your batteries by fastening an appropriate screw into the hole of the battery cover. An indicator on the front of the TV lights up and the screen comes on. When the set is in the High Security Mode, the Setup menu can be accessed only with an Institutional Set-up Remote Control (RG4172BK or RC2573). With the cursor left/right keys the protection can toggle between "YES" and "NO". Switch On/OSD: In this submenu the behavior of the TV after switching on and the behavior of the On Screen Display can be selected. Picture/Sound: In this sub-menu, the Picture and Sound settings of the TV can be selected. Security: In this sub-menu, the Security settings of the TV can be configured. Control: In this sub-menu, the Control settings of the TV can be configured. In this sub menu the behavior of the TV after switching on and the behavior of the On Screen Display can be selected. Welcome Message: Press Cursor Left/Right to display Welcome message entry menu: o Display o Line 1 o Line 2 o Clear With the Cursor Up/Down you can set the message characters. Power On: The Power On menu function defines the behavior of the television whenever AC Power is applied. the valid states are "FORCED ON" , "LAST STATUS" and "STANDBY". O When "FORCED ON", the television can only be switched OFF by means of the main switch or a set-up remote control or by ESP function (Energy Saving Programmability controls the maximum continuous viewing time allowed by the control system). In this sub menu, the Picture and Sound settings of the TV can be selected. [. . . ] The Clock set-up menu can be entered from this menu item (this menu option is only available on certain LCD TV models). Display Standby: This menu item will be used to set the intensity of the clock display when the television is in standby mode. Display On: This menu item will be used to set the intensity of the clock when the television is in the ON mode. Teletext Time Download: This menu item is used to activate or deactivate the function for automatic time downloading by means of Teletext. [. . . ]