User manual PHILIPS 50FD9934/01S

[. . . ] This symbol informs that there are contents that demand caution (including warnings). This symbol indicates a prohibited matter. This symbol indicates something that must be done. WARNING Ignoring this indication and improper handling could be the cause of personal injury such as a serious injury or death. When installing the plasma display or making angle adjustments, be sure to make a request for service with the dealer and ensure the work is performed according to this manual. Incorrect installation and angle adjustments may result in the plasma display falling and causing injury. [. . . ] Note: - The AUTO PICTURE, FINE PICTURE and PICTURE ADJ. menu items are not available with signals from a Video source. - The menu items FINE PICTURE and PICTURE ADJ. are available only when you select AUTO PICTURE OFF. J SELECT L M ADJUST MENU RETURN - Select RESET in the OPTIONS 1 menu to restore the predefined factory PICTURE settings. & Select MODE and press the cursor left/right to select a picture format (NORMAL or FULL in VGA-mode). é Select AUTO PICTURE ON or OFF. When having selected ON, the PICTURE ADJ. and FINE PICTURE adjustments are made automatically. When having selected OFF, the PICTURE ADJ. and FINE PICTURE adjustments can be made manually. FINE PICTURE adjusts for flickering; PICTURE ADJ. adjusts for striped patterns on the picture. V-POSITION adjusts the vertical position, H-POSITION adjusts the horizontal position, " Select V-POSITION, H-POSITION to adjust the position of the picture. Options 1 menu OSD Select OFF if you do not want On screen information like input source, screen mode, etc. to appear on screen during presentation, etc. 1-9 to position the menus that appear on screen. The position can be set between 1 and 9. OPTIONS1 OSD OSD ADJ. LONG LIFE RESET J SELECT L M ADJUST MENU RETURN ON POWER MGT. ON to turn the power management function on. The power management function is an energy-saving function and automatically reduces the monitor's power consumption if the computer's keyboard or mouse in not operated for a certain time. (See also the computer's operating instructions). Note: if the computer's power is not turned on, the power management function is set to OFF. GRAY LEVEL This control allows you to set the gray level for the sides of the screen when a normal 4:3 picture mode is displayed. It adjusts the brightness of the black for the sides of the screen. The standard is 0 (black) and the level can be adjusted from 0 to 15. The predefined factory setting is 3 (dark gray). CINEMA MODE Select CINEMA MODE ON to automatically discriminate and project the film image in a cinema mode suited to the picture (NTSC, PAL60, 480I, (60Hz) only). OSD ADJ. 1 4 7 2 5 8 3 6 9 8 Use of the menus and the menu system LONG LIFE (PLE INVERSE SCREEN WIPER PRESS OK TO SET TIMER FUNCTIONS AUTO) DVI ADJ This control allows you to select the most appropriate setting when the picture input from the DVI input extension is distorted. Note: When you adjust the DVI ADJ. , the position of the menu display will change. In such a case, be sure to adjust the position. [. . . ] Operating the set at a higher altitude (lower air pressure), the picture becomes unstable and the picture performance is deteriorating. The plasma display might then also produce a humming sound. After bringing the set below 2000 m (local air pressure equal or above 800 hPa) it works fine again. Transportation has no influence. Control of peripheral equipment The infrared radiation of the screen may influence the reception sensitivity of other peripherals. Solution: replace the batteries of the remote control or change position of other equipment. [. . . ]