User manual PHILIPS 56220-48-16

[. . . ] Allow to cool before putting on or taking off parts, and before cleaning the appliance. Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or has been damaged in any manner. The use accessory attachments not recommended by the appliance manufacturer may result in fire, electric shock or injury to persons. Do not let cords hang over edge of table or counter, or touch hot surfaces. [. . . ] Before cleaning the machine, you must deselect all buttons and remove the plug from the socket. It is strictly forbidden to tamper with the internal parts of the machine. Water left in the tank for several days should not be consumed. Wash the tank and fill it with fresh drinking water. For your safety and that of others, follow the "Safety Regulations" in section 3 carefully. Choose a level surface; · Choose a location that is sufficiently well-lit, clean and near an easily reachable socket; The machine's original packaging has been designed to protect it during transportation. We recommend keeping the packaging carton for possible future transportation. It is therefore necessary that the safety regulations be carefully respected. Faulty cords and plugs must be replaced immediately in authorized customer service centers. Make sure that the power button (2) is not pressed before connecting the machine to the power supply. 4A ) - Insert the plug into the socket on the back of the machine. 10) - Insert the portafilter (14) into the brew unit from the bottom (8). 11) - Turn the portafilter to the right, until it locks into place. 12) - Take 1 or 2 preheated cups and place them under the portafilter; check that they are correctly placed under the coffee brewing spouts. When the desired quantity of coffee has been reached, Before installing the machine, read the following safety instructions carefully. Make sure children cannot play with the machine; · Do not place the machine on hot surfaces or near open flames. The coffee machine is now ready to be connected to the power supply. Wait until a steady jet of water flows out of the steam spout (Pannarello). Close the hot water/ steam knob (7) by turning it clockwise (Fig. The machine is now ready to brew coffee and dispense steam. Press the brew button again (4) to stop the coffee brewing and remove the cups of coffee (Fig. 15) - Wait a few seconds after brewing, then remove the portafilter and empty the coffee grounds. [. . . ] Wait until the machine ready light (5) turns on again. 17) - Insert a container below the steam spout and open the knob (7) for a few seconds, so that any residual water flows out of the steam spout (Pannarello). Wait until there is a steady jet of steam coming out of the spout. Fill 1/3 of a frothing pitcher or large mug with cold milk. [. . . ]