User manual PHILIPS 56333-30-16

[. . . ] 19 Resolution & Preset Modes. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 22 Power Management . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 Automatic PowerSaving. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 23 Regulatory Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] This data is subject to change without notice. Go to www. philips. com/support to download the latest version of leaflet. This monitor is brominated flame retardant and polyvinyl chloride-free (PVC/BFR free) for all user accessible parts (excluding cables and adaptors). Organobromine compounds in the form of flame retardants must not be used in those portions equal to or greater than 0. 09%(900ppm maximum of Bromine) and organobromine compounds in the form of polyvinyl chloride or polyvinyl chloride congeners must not be used in those portions equal to or greater than 0. 1% (1000ppm maximum of Chlorine). 20 4. Technical Specifications 4. 1 Resolution & Preset Modes Maximum Resolution For 273E3L/273E3LH 1920 x 1080 at 60 Hz (analog input) 1920 x 1080 at 60 Hz (digital input) Recommended Resolution For 273E3L/273E3LH 1920 x 1080 at 60 Hz (digital input) H. freq (kHz) 31. 47 31. 47 35. 00 37. 86 37. 50 37. 88 46. 88 48. 36 60. 02 63. 89 79. 98 55. 94 70. 64 65. 29 67. 50 Resolution 720x400 640x480 640x480 640x480 640x480 800x600 800x600 1024x768 1024x768 1280x1024 1280x1024 1440x900 1440x900 1680x1050 1920x1080 V. freq (Hz) 70. 09 59. 94 66. 67 72. 81 75. 00 60. 32 75. 00 60. 00 75. 03 60. 02 75. 03 59. 89 74. 98 59. 95 60. 00 21 5. Power Management 5. Power Management 5. 1 Automatic PowerSaving If you have VESA DPM compliance display card or software installed in your PC, the monitor can automatically reduce its power consumption when not in use. If an input from a keyboard, mouse or other input device is detected, the monitor will 'wake up' automatically. The following table shows the power consumption and signaling of this automatic power saving feature: 273E3L Power Management Definition VESA Mode Active Sleep (Standby) Switch Off Video ON OFF OFF H-sync V-sync Yes No Yes No Power Used <27 W (typ. ) < 0. 5 W < 0. 5 W LED color White White (blink) OFF 273E3LH Power Management Definition VESA Mode Active Sleep (Standby) Switch Off Video ON OFF OFF H-sync V-sync Yes No Yes No Power Used <27. 3 W (typ. ) <32. 3 W (max. ) < 0. 5 W < 0. 3 W LED color White White (blink) OFF The following setup is used to measure power consumption on this monitor. Native resolution: 1920 x 1080 Contrast: 50% Brightness: 300 nits Color temperature: 6500k with full white pattern Note This data is subject to change without notice. 22 6. Note We recommend you switch off the monitor when it is not in use for a long time. 24 6. Regulatory Infomation Federal Communications Commission (FCC) Notice (U. S. Only) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorientorrelocatethereceivingantenna. Increasetheseparationbetweenthe equipment and receiver. Connecttheequipmentintoanoutleton a circuit different from that to which the receiver is connected. Consultthedealeroranexperiencedradio/ TV technician for help. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. FCC Declaration of Conformity Declaration of Conformity for Products Marked with FCC Logo, United States Only This device complies with Part 15 of the FCC Rules. [. . . ] Troubleshooting & FAQs Q8: Can I change the color setting of my monitor?Ans. : Yes, you can change your color setting through OSD control as the following procedures, ·Press"OK"toshowtheOSD(OnScreen Display) menu ·Press"DownArrow"toselecttheoption "Color" then press "OK" to enter color setting, there are three settings as below. Color Temperature; The six settings are 5000K, 6500K, 7500K, 8200K, 9300K and 11500K. With settings in the 5000K range the panel appears `warm, ' with a red-white color tone, while a 11500K temperature yields `cool, blue-white toning. " 2. [. . . ]