User manual PHILIPS 69087-87-16

[. . . ] Always tighten the terminal screws firmly, especially the attachment for low voltage wiring (12V) (if applicable). Observe the correct colour of the wiring before installation: blue (N), brown (L) and if protection class I, yellow/green (earth). Maintain interior lighting with a dry cloth duster, do not use abrasives or solvents. Please mount wall lights out of children's reach. [. . . ] 18- Immediately replace a cracked or broken safety glass and use only manufacturer approved parts. 19- Protection class I: the fitting has an earthing connection. The earth wire (yellow/green) has to be connected to the clip marked with . 20- Protection class II: the fitting is double insulated and must not be connected to an Earth. 21- Protection class III: the fitting is only suitable for very low voltage supply (e. 23- The earthing wire always has to be longer than the contact wires. 26- The fitting is only suitable for wiring directly into the mains. W: only use lamps suitable for this fitting and keep within the maximum specified wattage. 32- Only an incandescent lamp with a diameter of 60mm can be used. A lamp with a 45mm diameter must not be used for this fitting. 33- Only use an incandescent globe bulb that is the size of the indicated diameter. 35- Never use "cool-beam" lamps for this fitting. 36- The fitting is only suitable for a lamp with built-in safety or a low pressure lamp. If the fitting is out of order after the bulb has been replaced, the internal fuse has to be replaced. If contact with the internal wiring can be made during this operation, this should be done by a competent electrician. 39- The fitting can be used in combination with a dimmer with exception where PLCE-lamps are used. consult a qualified electrician for choosing the right type (especially important for 12V-fittings). 40- The fitting is working with a safety transformer. Replace a broken transformer only with a transformer with identical technical specifications. 42- Fitting with time and light setting options. [. . . ] Any damage caused to the light fitting in extreme conditions (coastal areas, industrial surroundings, farm environments) will not be covered by the guarantee. The period of guarantee starts from the purchase date and is only valid on presentation of the receipt. The guarantee is void if the fitting was not installed following the instructions or repaired or modified. The manufacturer does not accept any liability for damage caused as a result of misuse or wrong application of the fitting. [. . . ]