User manual PHILIPS 69148-30-PH

[. . . ] LivingColors will flash 3 times, and then quickly flash green. the linked lamps will turn to the last setting of the remote control. - Repeat this operation for each LivingColors lamp that you want to link with the others. - To use the LivingColors separately again, link it to another remote control in the same way as described above. [. . . ] Insert the pole into the foot, and then turn the pole clockwise until you cannot turn it anymore (drawing 1). Insert the connection plug into the opening under the foot of the lamp (drawing 2) and plug its other end into the wall socket. Insert the connection plug on top of the stand into the lamp ­ make sure you hear a click (drawing 3). Position the lamp on the stand and direct LivingColors towards the wall (the optimal distance is 50 cm) ­drawing 4. livingColors will show a short introduction of the colour possibilities. You can adjust the height of the luminaire by turning the ring in the middle of the stand, pulling the top part of the stand to the desired height, then turning the ring back to fix the position (drawing 5). You can move your finger over the colour wheel to refine the colour (drawing d) -Changing the colour saturation (adding more white to the current colour). Press on ( ) for a deep colour or on ( ) for a more pastel colour (drawing a). Ultimately you will reach the white colour. LivingColors will remember your last colour setting for your next usage (drawing c). Problem LivingColors is not providing light Possible cause The lamp is not plugged in correctly Remote control is not working Solution Check the connections of the cord to the lamp Check that the plug is correctly placed in the wall socket See the following section Check the batteries in the remote control. The batteries should be correctly placed (+ and -) and should be charged. If the remote control is still not working, try replacing the batteries. link the remote to the LivingColors lamp by following the procedure under "2. Linking LivingColors lamps" Move LivingColors away from the wireless access point Make sure that all LivingColors connected to this remote are on; otherwise they will not respond after this action. Press simultaneously on "0" and ( ) for at least 5 seconds to switch to another channel (all LivingColors will flash green to confirm). You can repeat this procedure up to 3 times, preferably from another position. If it was linked successfully, the lamp will give 1 green flash; if the linking was unsuccessful it will revert to its previous settings immediately without flashing green. Check if the lamps you cannot link both have a "G2" sign on the back of the remote control and at the bottom of the lamp itself. If one of the lamps does not have it, it cannot be linked with another lamp that does (but it can still be linked with other lamps that do not have the G2 sign). [. . . ] Warranty: Philips' two-year warranty is valid if the product is used in accordance with the instructions and for its intended purpose. Claims will only be accepted on submission of the original proof of purchase (invoice, sales slip or receipt) stating the purchase date, the name of the dealer and a description of the product. The Philips warranty lapses if: - Anything has been changed, crossed out, deleted or rendered illegible on the purchase docket or product description. - Failures caused by damage , faulty connections or abuse. [. . . ]