User manual PHILIPS 70998/30/PH

[. . . ] Colour intensity (saturation): If you want to add more white to your current colour or make your colour intense (saturated) again, you can easily change the colour intensity (saturation). Just press the colour wheel on the left (more white) or right (more colour) position. If you keep pressing on the left position, you will ultimately reach white. Discovering your LivingColors Extended functionality Automatic Colour Change Mode: You can also let your LivingColors change colours automatically. [. . . ] = 5 sec LED = 5 sec LED How to use multiple LivingColors?Connecting multiple Philips LivingColors If you have multiple LivingColors at home, you can all use them with just one remote control. To connect the different LivingColors to the same remote control, follow the instructions below. Hold the “I”-button until the LivingColors displays a green light. It is now connected to the remote control. 10sec = max 5cm Repeat this procedure for every product you want to add to this remote control. After connecting all of the products to the remote control, you will be able to let them all change colour at the same time. The same colour will be displayed by all of your LivingColors products by only using one remote control. products to your remote control (50 products maximum). If the logo is not on the Note: You can only connect/add other packaging/product, the product cannot be added to the system. For the LivingAmbiance luminaires, please make sure that you connect both the coloured light (top of the shade) and white light (at the foot or ceiling plate). Disconnecting multiple Philips LivingColors (optional) If you connect another remote control to the same luminaire, it will be automatically disconnected from the first remote control (unless the two remotes were connected first - see further). Alternatively, you can disconnect a remote control from a luminaire as follows: Hold the remote control against the Philips logo on the lens of the product, then press and hold the “0”-button. Hold the “0”-button until the LivingColors is switched off automatically. 10sec = max 5cm Connecting additional Remote Controls You can control the same products with several remote controls. This is convenient if, for example, you want to leave one remote control in the kitchen and another one in the living room. Step 1: Always reset the additional remote control first. Open its battery compartment and press the RESET button for a few seconds. [. . . ] The batteries should be correctly placed and inserted (+ and -). If the remote control is still not working, try replacing the batteries. If necessary, connect the remote control to the LivingColors again (same way as connecting multiple LivingColors to one remote control). 10sec = max 5cm Solution 2: Perform a channel switch In rare cases, problems with the connection between your LivingColors and the remote control could be caused by heavy traffic on the wireless network (e. [. . . ]