User manual PHILIPS 9160XL

[. . . ] IMPORTANT SAFETY INSTRUCTIONS When using an electric razor, basic precautions should always be Followed, including the following: Read all instructions before using this appliance. Do not reach for a corded razor/charging stand that has fallen into water. Do not use a razor/charging stand while bathing or in a shower. Do not place or store a razor or charging stand where it can fall or be pulled into a tub or sink. [. . . ] Use an attachment plug adaptor of the proper configuration for the power outlet. the charging plug will automatically convert to work on 100V to 240V AC systems. First time charging and recharging after non-use for 1 month or more requires a full 4 hours. a fully charged razor has a cordless shaving time of up to 30 days. When batteries are fully charged, all the "lights" in the display will light up green. A few hours after charging, all lights go off. Do not leave the charging stand with the razor in it continuously plugged into outlet as it would reduce life of batteries. If storing razor in stand, remove the plug from outlet as soon as the razor is fully charged. Recharge only when the bottom light on the display lights up red. As you charge razor, the bottom light on the display turns red. After approximately 3 minutes, it will then turn green and blink. As charging continues, more and more lights of the display meter will briefly blink green and light up to indicate what level of the batteries have been charged. When razor is fully charged, disconnect the charging plug from outlet. Do not keep razor or charging stand permanently plugged into outlet. If using charging stand, always remove razor from stand by lifting straight up. When batteries are totally depleted, recharging the razor for approximately 3 minutes gives enough energy for a 3-minute cordless shave. All of the lights on the Charge Meter will blink sequentially when the battery contains enough energy for a 3-minute cordless shave. Settings that allow you to personalize your shave for your specific skin type from sensitive to normal skin. You can select your personal comfort control setting by turning the dial. It is a fact that your skin and beard need time to adjust to a new shaving system. Use your new razor exclusively for 3 weeks to fully enjoy the closeness of a Philips Norelco shave. At first you may not get as close a shave as you expect, or your face may even become slightly irritated. [. . . ] Press the razor head release button to open the razor head assembly. Clean outside of Razor Head Assembly by running under hot water. Close the Razor Head Assembly and shake off excess water. Philips Norelco Razor Cleaner, model RC1776, or rubbing alcohol) and lubricated with Philips Norelco Razor Lubricant, model AL80, or one drop of mineral oil (in the center of the head). [. . . ]