User manual PHILIPS AEA3000

[. . . ] • Perchlorate Material-special handling may apply. See www. dtsc. ca. gov/ hazardouswaste/perchlorate. l Apparatus shall not be exposed to dripping or splashing, keep it away from direct sunlight, naked flames or heat. [. . . ] We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet. ) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. Please observe the local regulations regarding the disposal of packaging materials, exhausted batteries and old equipment. EN 3 English 2 Your Wireless Microphone and Receiver Congratulations on your purchase, and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. philips. com/welcome. If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the back of the apparatus. ___________________________ b d c a a Line out socket • (To use the microphone separately) connect to the MIC input socket of an existing Hi-Fi system. b Battery compartment c OFF/ON • Switch the microphone on or off. d Power indicator • Light up red when the wireless microphone is switched on. • Flash red when the battery level is low. Receiver Introduction With the Philips wireless microphone and receiver, you can: • connect the receiver to your iPad (or both your iPad and an existing Hi-Fi system), and sing along with music from the app (The Voice: On Stage) through the wireless microphone. What's in the box Check and identify the contents of your package: • Wireless microphone • Receiver • 3 x AAA batteries • Quick start guide • Safety sheet a iPad connector a b c b Bluetooth® indicator • Indicate the Bluetooth® status. c LINE-OUT • Connect the receiver to an existing Hi-Fi system. Overview of the unit Wireless microphone 4 EN Always follow the instructions in this chapter in sequence. Install/replace microphone batteries Caution •• Risk of explosion!Keep batteries away from heat, •• Danger of explosion if batteries are incorrectly sunshine, or fire. Replace only with the same or equivalent type. •• Batteries contain chemical substances, so they should be disposed of properly. 3 Push back the battery cartridge, then close the battery compartment. Note •• If you are not going to use the microphone for a long •• New batteries installed in the microphone support up time, remove the batteries. to 30 hours of continuous use. 1 Open the battery compartment and take out the battery cartridge. •• When the power indicator flashes red, it indicates that the power level is low and you need to replace the batteries. 2 Insert 3 x AAA batteries (supplied) into the cartridge with correct polarity (+/-) as indicated. EN 5 English 3 Get started 4 Play Sing along through the wireless microphone Note •• The effective operation range between the wireless microphone and receiver is approximately 10 meters (30 feet). 4 Slide the OFF/ON switch on the wireless microphone to the ON position. »» The Bluetooth® indicator on the receiver flashes blue. [. . . ] •• As a power-saving feature, the microphone switches to standby mode automatically after staying disconnected from the receiver for more than 15 minutes. To switch it on again, you need to slide the OFF/ON switch on the microphone to the OFF position and then back to the ON position. No sound or poor sound •• Adjust volume on the iPad. [. . . ]