User manual PHILIPS AJ3500

[. . . ] Where the MAINS plug or an appliance coupler is used as the disconnect device, the disconnect device shall remain readily operable. 2 Your clock radio Congratulations on your purchase, and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. philips. com/welcome. Introduction With this unit, you can: · listen to FM/MW radio; · know the time; · set two alarms; and · wake up by buzzer alarm or FM/MW radio. What's in the box Check and identify the contents of your package: · Main unit (with a battery) · User manual If you contact Philips, you will be asked for the model and serial number of this apparatus. The model number and serial number are on the bottom of the clock radio. [. . . ] When power is connected, the clock is set automatically. Select time zone Check if the time of the clock radio is consistent with the local time. If not, adjust the time zone settings according to your location. » The current time zone number blinks on the display panel. 2 Press TIME ZONE repeatedly to select time zone. For Australia: Australian Western Standard Time (AWST) Australian Central Standard Time (ACST) Australian Eastern Standard Time (AEST) New Zealand Standard Time (NZST) +8 +9. 5 +10 (default) +12 For United Kingdom and Ireland: Western European Time (WET) +0 (default) Set clock c In standby mode, you can set clock manually. Tip · In clock setting mode, press and hold HR/MIN for one second, and the hour/minute digits increase or decrease continuously. Select DST (daylight saving time) mode For countries with daylight saving time (DST), the clock radio offers you DST option to adjust summer time. In standby mode, press and hold 12/24H·DST for two seconds. » The clock advances by one hour and [DST] is displayed. Tip · To exit DST mode, repeat the above operation. · To select 12/24 hour format, press 12/24H·DST repeatedly. 4 Set alarm timer Set alarm time d In standby mode, you can set two alarms to ring at different time. Note · In alarm setting mode, press and hold HR/MIN for one second, and the hour/minute digits increase or decrease continuously. Select alarm sound To select the last heard channel or buzzer as alarm sound, switch AL1/ AL2 RADIO·BUZZ to left or right. Tip · The gentle wake-up function is designed for all alarm sources. Activate/deactivate alarm timer 1 2 Press AL1/AL2 to view alarm settings. Press AL1/AL2 again to activate or deactivate the alarm timer. » or appears if alarm timer is on and disappears if it is off. · To stop alarm, press the corresponding AL1/AL2. · The alarm repeats ringing for the next day. Note · When alarm sounds, you cannot adjust volume by rotating VOL. Snooze alarm When alarm sounds, press SNOOZE. » The alarm snoozes and repeats ringing five minutes later. To adjust alarm interval (in minutes), press SNOOZE repeatedly. 5 10 15 20 25 30 5 Listen to radio Tune to radio stations e Tip · Position the antenna as far as possible from TV, VCR, or other radiation source. · For better reception, fully extend and adjust the position of the antenna. Adjust volume f 6 Other features Set sleep timer This clock radio can switch to standby mode automatically after a preset period. [. . . ] Please act according to your local rules and do not dispose of your old products with your normal household waste. Correct disposal of your old product helps to prevent potential negative consequences for the environment and human health. Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be disposed with normal household waste. Please inform yourself about the local rules on separate collection of batteries because correct disposal helps to prevent negative consequences for the environmental and human health. Environmental information All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate into three materials: cardboard (box), polystyrene foam (buffer) and polyethylene (bags, protective foam sheet. ) Your system consists of materials which can be recycled and reused if disassembled by a specialized company. [. . . ]