User manual PHILIPS AT750/20

[. . . ] Register your product and get support at www. νικα 41 Español 55 Suomi 68 Français 80 Français (Canada) 93 Italiano 106 Nederlands 118 Norsk 131 Português 143 Svenska 156 Türkçe 168 4 English Introduction Congratulations on your purchase and welcome to Philips!To fully benefit from the support that Philips offers, register your product at www. Please read this user manual, as it contains information about the wonderful features of this shaver as well as some tips to make shaving easier and more enjoyable. [. . . ] 3 After shaving, press the on/off button once to switch off the shaver. 4 Clean the shaver (see chapter ‘Cleaning and maintenance’). 9 Trimming (AT940/AT893/AT891/AT890 only) You can use the trimmer to groom your sideburns and moustache. 1 Push the trimmer slide downwards to open the trimmer. 2 Press the on/off button once to switch on the shaver. 3 After trimming, press the on/off button once to switch off the shaver. Cleaning and maintenance Never use compressed air, scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone to clean the shaver and the charging stand (AT940 only). Always unplug the shaver before you clean it under the tap. -- Clean the shaver after every shave for optimal shaving performance. -- Regular cleaning guarantees better shaving performance. -- For the best cleaning results, we advise you to use the Philips Cleaning spray (HQ110). Always check if the water is not too hot, to prevent your hands from getting burnt. Note:Water may leak from the socket at the bottom of the shaver when you rinse it. This is normal and not dangerous because all electronics are enclosed in a sealed power unit inside the shaver. 10 English Cleaning the shaving unit under the tap 1 Switch off the shaver. 2 Press the release button to open the shaving unit. 3 Rinse the shaving unit and hair chamber under a hot tap for 30 seconds. Always check if the water is not too hot, to prevent your hands from getting burnt. -- Rinse the hair chamber and the inside of the shaving unit. -- Rinse the outside of the shaving unit. 4 Close the shaving unit and shake off excess water. Be careful not to hit the shaving unit against anything while shaking off excess water. [. . . ] The temperature of the shaver is too high. As soon as the temperature of the shaver has dropped sufficiently, you can switch on the shaver again. Recharge the battery (see chapter ‘Chargin’) and disconnect it from the mains. The shaver does not work, although it is connected to the mains. [. . . ]