User manual PHILIPS AW2000

[. . . ] Helpful hints: The searching will stop 10 minutes later if no time signal is received. RCC time will auto be updated at 2: 00 am every day. You don't need to re-adjust to your local time if Manual setting You may also set or adjust time manually. Press and hold TIME SET / RCC SYNC for 2 seconds. Hold down or press TUNING +/- repeatedly to adjust the time digits. [. . . ] To tune to a weak station, press TUNING +/- briefly and repeatedly until you have found optimal reception. To improve reception: FM: Extend and adjust the pigtail for optimum reception. Programming radio stations You can store up to a total of 10 radio stations in the memory (10 FM) manually or automatically (Auto store). Manual programming 1 2 Tune to your desired station (see Tuning to radio stations). Press and hold PRESET +/- to activate programming. Press PRESET +/- once or more to allocate a number from 1 to 10. Repeat steps 1-3 to store other stations. Helpful hints: You can erase a preset station by storing another frequency in its place. Autostore Autostore automatically starts programming radio stations from preset 1. In radio mode, press AUTO SCAN/DATE until the frequency in the display starts running. 1 2 3 5 6 1 2 3 4 Alarm Available stations are programmed (FM). Each weather forecast status will be displayed with graphical animation and different lighting colors at the top left hand corner of the unit, see the figure below. About color lighting ­ Battery operation:The light turns on for 10 seconds after each atmospheric measurement, or after any button pressed. ­ AC operation:The light always turns on when the power is switched on. To let the light turn on just like the case of battery operation mentioned above, press and hold REPEAT ALARM/BRIGHTNESS CONTROL for about 10 seconds. 1 Sleep The clock radio has a built-in sleep timer, which enables the set to be automatically switched off during radio playback after a set period of time. 1 Setting the sleep time During radio playback, set your timer by pressing repeatedly SLEEP until the desired timer option appears. Selections are follows (time in minute) 10=20=30=60=90=120=OFF= 10 The set will turn off automatically at the selected time. To cancel the timer function, either press SLEEP once or more until "OFF" appears, or press RADIO ON/OFF to switch to standby. "SLEEP" disappears when sleep function is cancelled. Note: ­ The sleep function does not affect your alarm time setting(s). 2 3 Temperature and humidity Notes: ­ The weather forecast based on the atmospheric pressure may vary slightly from the actual weather situation. ­ The weather forecasts from this unit are predictions that covers the next 12 to 24 hours. It may not necessarily reflect the current situation. · press and hold AUTO SCAN /DATE for about 3 seconds to force the main unit to search for the remote sensor signal. [. . . ] The brightness of the display can be adjusted: Bright Low Off Bright · · Low battery indication When the batteries of the main unit or the sensor are running low, the low battery icon will be displayed on the main unit, or the sensor, indicating that the batteries should be replaced soon. When the outdoor temperature is updating with the sensor searching, is displayed on the main unit. (See 4) To Improve the sensor reception In case of intermittent/no connection, slide the CHANNEL switch to Channel 2 or 3, located in the battery compartment of the sensor, then repeat the setup connection described above. reduce the distance between the sensor and the main unit. · · Safety and maintenance Safety and general maintenance · If you do not intend to use the clock radio for a long time, withdraw the power cord from the wall outlet. Place the set on a hard and flat surface so that the system does not tilt. [. . . ]