User manual PHILIPS AZ105C

[. . . ] • Do not mix batteries (old and new or carbon and alkaline, etc. ). • Remove batteries when the unit is not used for a long time. Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like. [. . . ] Make sure that the power Connect the AC power cord to: • the AC~ MAINS socket on the unit. • the wall socket. Note •• To switch the unit off completely, disconnect the power cord from the power supply socket. EN 6 Turn on Switch the source selector to FM, Audio-in, or CD. AC~MAINS Turn off Switch the source selector to OFF. Option 2: Battery power Caution •• Risk of explosion!Keep batteries away from heat, •• Batteries contain chemical substances, so they should be disposed of properly. Never discard batteries in fire. Switch to standby mode If the unit is idle for 15 minutes, it switches to standby mode automatically. To exit the standby mode: • Press ; or • Select a source. Note •• Batteries are not supplied with the accessories. 1 2 3 Open the battery compartment. Insert 6 batteries (type: R14/ UM2/ C CELL) with correct polarity (+/-) as indicated. Close the battery compartment. 7 EN 4 Play Play disc 1 2 3 Switch the source selector to CD. Insert a disc with the printed side facing up, then close the disc compartment. »» Play starts automatically. 4 5 Repeat steps 3 to program more tracks. »» During play, [PROG] (program) and the preset number are displayed. • To erase the program, press twice. Listen to FM radio Note •• Position the antenna as far as possible from TV, VCR or •• For optimal reception, fully extend and adjust the position of the antenna. other radiation source. Control play Select an audio file; Press and hold to fast-forward or fast-reverse the track during playback, then release to resume play. REPEAT [ ]: Play the current track repeatedly. / 1 2 Switch the source selector to FM. Rotate - TUNING + to tune to an FM radio station. Play from an external device You can also listen to an external audio device through this unit. 1 2 Switch the source selector to Audio-in. Connect an audio cable (3. 5mm, not supplied) to: • the Audio-in socket on the unit. • the headphone socket on an external device. Play the external device (see the device's user manual). Note Enhance bass To turn dynamic bass boost on or off, slide DBB switch to ON or OFF. 3 Program tracks You can program a maximum of 20 tracks. •• The Audio-in socket is not for headphones. 1 2 3 Press to stop playback. Press PROG to activate the program mode. [. . . ] Any changes or modifications made to this device that are not expressly approved by Philips Consumer Lifestyle may void the user’s authority to operate the equipment. Your product is designed and manufactured with high quality materials and components, which can be recycled and reused. When this crossed-out wheeled bin symbol is attached to a product it means that the product is covered by the European Directive 2002/96/ EC. Please inform yourself about the local separate collection system for electrical and electronic products. Please act according to your local rules and do not dispose of your old products with your normal household waste. [. . . ]